for headlamps with centres at 850mm or less from the ground, the beam image horizontal cut-off is between the 0.5% and 2.75% horizontal lines

The cause of these failures is water ingress, despite them looking like a very well sealed unit. Mine was completely undamaged but did have quite a fair bit of water inside. Summarily, these 5 factors explained above are the most common led tailgate light bar problems, and we included the possible fixes you could try for each. Tricycles and quadricycles classed as mopeds do not need hazard warning lamps. Only ‘bodied’ mopeds must have direction indicators. Defect

On some vehicles it may be necessary to have the engine running before the reversing lamps will work. Defect Vehicles first used before 1 January 1971 may be fitted with only 1 stop lamp, which can be mounted centrally or towards the offside. However, if you don’t mind the holes, combining adhesive tape with screws actually creates a more secure connection between the light bar and the tailgate—such a setup would be recommended if you often drive off-road. Verdict Additional stop lamps, over and above the obligatory requirements, must be tested. However, if you are not sure that they’re connected, you should give the benefit of the doubt.

Most rear light assemblies combine stop lights, indicator lights (for braking and turning), and fog lamps. Your rear lights must comply with all the relevant vehicle legislation. It is your duty to make sure your rear lights are working properly in both low and high beams. Wiring faults can range from broken cables to improper connection (plugging the wires into the wrong ports). This problem usually occurs if you do the tailgate light bar installation yourself. Well, never to worry; you can still fix this up. Solution(s): Vehicles do not need to be fitted with position lamps, or may have such lamps permanently disconnected, painted over or masked if they are: That look like it would fit BUT why it has a different part number to what was on mine, I don't know. It does look as if it is considerable darker too, again that nay be the quality of the photograph and lighting conditions.Not tested” or “Unable to be tested” must only be used where it becomes apparent during the test that the particular item cannot be tested, and this could not have been identified prior to starting the test. The reason for selecting the failure must be included in the additional information box. Defect Switch on the rear fog lamps and operate all the other lamps in turn to see if the rear fog lamps are adversely affected. Rear reflectors are not required on vehicles not fitted with front and rear position lamps, or have such lamps permanently disconnected, painted over or masked and are: