Upgrade your VW Golf 7 with the GTi Style LED Headlights, a high-quality lighting solution available at MCG Autostyling. The data has been generated with highest diligence but may in reality not represent the complete possible variation range of all component parameters.

Our factory has American DOT, European E-Mark, and Chinese CCC certification to assure product quality. If you have purchased lamps without any additional lighting elements like halos or LED lights, you are done with the electrical installation. Systematic quality assurance measures underpin the premium workmanship and functionality of our products. While most condensation in the headlight lens usually dissipates after approximately 20 minutes of driving with the low beams switched on, some small and insignificant areas of the lens may remain misted for a little longer. Disadvantages: These are NOT plug and play, they require some reasonable DIY experience for both vehicles and electrics.You will need to remove the signal bulb from the old lamp (do NOT disconnect any wires) and install it, in its existing housing, into the new lamp. Accessories that may come on an engine such as fuel systems, distributors, electronic components, manifolds and water pumps, sumps, etc. The lights have a series of amber LEDs that can be configured as a rear switch, providing a more concentrated light output compared to regular headlights. Then you’ll need a rivet gun to reinstall new ones – not an expensive purchase, but the proper tool to use. The additional charge for customs clearance is down to the recipients responsibility and we have no control over these charges.

Disadvantages: Seems to sit a bit lower than original/there’s a slightly larger gap between the bonnet and light, larger than the thickness of seal on the underside of the bonnet. Please note all parts supplied, are marked with our company stamp/initials, removal of these marks will invalidate your guarantee/warranty. Therefore, in certain cases a deviation between the real optical, thermal, electrical behaviour and the characteristics which are encoded in the provided data could occur.Lorem ipsum dolor sit amet, consetetur sadipscing elitr, sed diam nonumy eirmod tempor invidunt ut labore et dolore magna aliquyam erat, sed diam voluptua. In the event your vehicle manufacturer has used rivets to secure things (wheel well areas), they’ll need to be drilled out with a traditional drill.

A visually stylish, plug-and-play LED replacement for your front light units that gives them a much more modern vibe.

Remember, unless you disconnected them earlier from behind, electrical wiring harnesses are still attached. Compared to minimum ECE R112 requirements | 2 When compared with standard headlights with halogen lamp | 3 Refer to www. Usually, either a simple squeeze on the edges of the connector or pulling up on a tab is enough to cause the connector to release its grip, but if a thin wire bar is present, it usually needs to be slid into an unlocked position first.