The Hikvision DS-2CD2347G2-LU(2.8MM)(C) is a 4 Megapixel (4MP) Ultra HD IP-POE Gery Turret Camera available in a 2.8mm fixed focal length. Together with high-end Hikvision memory card, memory card encryption and health detection are supported ColorVu Technology works to provide full colour images 24/7. The camera is able to achieve this with a large iris, high-performance sensor and built-in white LED supplement lighting.

Audio Bit Rate -U: 64 Kbps (G.711ulaw/G.711alaw)/16 Kbps (G.722.1)/16 Kbps (G.726)/32 to 192 Kbps (MP2L2)/8 to 320 Kbps (MP3)/16 to 64 Kbps (AAC) Please note, we strongly recommend that the latest Easy IP 4.0 cameras should be used with the -I series NVR only. Please see our comments on our technical forum for more information. Audio Bit Rate 64 Kbps (G.711ulaw/G.711alaw)/16 Kbps (G.722.1)/16 Kbps (G.726)/32 to 192 Kbps (MP2L2)/8 to 320 Kbps (MP3)/16 to 64 Kbps (AAC-LC) MicroSD/SDHC/SDXC card (256 GB) local storage, and NAS (NFS, SMB/CIFS), auto network replenishment (ANR)

I have registered and trying to add my device keeps saying device off line. No search results found.

However when I go to the motion detection linkage method, only the following options are available: Narrows down the angle and zooms in to look past the immediate area a little to gain more detail – down a driveway for example from higher up Day time images are as good as can be for a 4mp 1/1.8 sensor though I prefer to adjust the exposure up a notch, night time needs additional light if you dont want to use the built in LED lighting, I use a 10w porch light that works to light up my driveway and this works pretty well. The DS-2C2347G2-LU now also draws from the same deep learning algorithm that is featured in AcuSense technology. This enables the camera to focus on human and vehicle classification and reduce the occurrence of false alarms. For seeing as much of the immediate area as possible such as above a doorway/low down/garage soffits (edges can appear slightly warped/distorted) – clearly “zoomed out”

Is it safe to assume that my mistake was to upgrade to the latest firmware rather than the firmware that specifically allows motion detection activation for supplemental light? Start up And Operating Conditions -30 °C to 60 °C (-22 °F to 140 °F). Humidity 95% or less (non-condensing) Smart Event Line crossing detection, intrusion detection, region entrance detection, region exiting detection