Clean the window thoroughly. Remove paint, grease and other dirt. If any is left behind, it will always be visible! Make sure to not apply window film in direct sunlight, make sure the temperature of the window film, the window it self and the surrounding air is -ideally- around 12 to 18 degrees Celsius. When the temperature is above 18 degrees we advise you to apply the window film during the early mornings or after sundown. The higher the temperature the more difficult it is to apply the frosted window film! You are generally supplied with bubble free frosted window film. So no water is required. However, if you are inexperienced or are applying very large films with few cut-outs, you can use water, if you desire so. Use a plant sprayer to add a fine mist of water to the glass. Use your supplied free squeegee. Start in the middle/centre of the window film and move horizontal or vertical with overlapping movements towards the edge of the window film. During which you hold the window film a couple centimetres (2 inches) above the window/mirror itself.

Use 2 or more people when applying your frosted window film. One holding the top/left of the film and one holding the bottom/right to position the window film correctly. Subsequently, during application one holds the film a couple of centimetres above the surface, while the other cards with the squeegee, starting in the centre of the frosted window film. Extensively clean the window and the surrounding area, including you work environment. Clean it of durst, dirt, flies, spiders. Watch out for your fingerprint on the window glass itself. Also clean the surrounding area, like the window frame itself and your work environment. If you are applying near the ceiling and/or the ground make sure they are also clean. Also be wear of flying insects and pets. Make sure to not apply window film in direct sunlight, make sure the temperature of the window film, the window itself and the surrounding air is -ideally- around 12 to 18 degrees Celsius. When the temperature is above 18 degrees we advise you to apply the window film during the early mornings or after sundown. Apply the window film with the application-tape to the window, position it at the preferred location.If you just want to have plain frosted window film, you can also buy it off the roll. The window film is available in different widths which you can view and get prices by visiting this link; plain frosted window film on a roll. How do I apply frosted window film? Watch our instruction video on how to apply frosted window film. Some general information about how to apply window film Use the supplied squeegee and card over the application-tape on the front of the frosted window film to further increase the binding between the two. Use a sturdy flat surface, like a table. Static Cling Frosted Film: Designed for temporary use, easily removable, making it suitable for both renters and homeowners.

Below you find instructions on how to apply your bespoke frosted window film (cut). You have been supplied with bubble free window film. So application without water is possible. If you are supplied with a WET APPLY frosted window film always use water.