The stainless steel Insofast ISF18 is a similar fixing that includes an 18mm head. It is perfect for fixing plywood or OSB faced insulation sheets to rafters in warm flat roof appli­cations. The ISF18 is also available in zinc-plated steel. Non-combustible fixings for fastening insulation to concrete soffits Note: For heavy wall-mounted parts, use independent horizontal battens. You may also need longer fixings to fit heavy items to the masonry, separate from the battens. Insulation fixings and screws are vital for ensuring each type of insulation is secured properly. Using the correct hardware will make sure everything from plasterboard to multifoil stays in place and doesn’t get damaged.

points to keep in mind while using project specific pressure vessel nozzle load tables during stress analysis The solid wall has a similar installation method to the upgrading cavity walls, with a few minor tweaks – such as the type of board that can be used. Once again, if you’re hoping to improve the performance of your solid wall then adding more insulation to the outer face of the wall is not always a possibility. Step two: Apply a continuous band of adhesive to ensure a continuous seal is at the skirting, ceiling level and openings. Thin timber battens can replace adhesive at perimeter edges. Add additional adhesive where necessary, according to manufacturer instructions, Step one: Make sure walls are in a good condition and suitable for internal linings – take care to remove any vinyl wallpaper or gloss pain to leave the wall surface clean, dust-free and free from loose material(s). Ensure the wall is also dry, having any remedial work done prior to installation of the boards to remove dampness.Note: Avoid the load being directly applied to the Celotex PL4000. Mechanical fixings suited should be used for other internal fittings. Seek advice regarding suitable fixings from the manufacturer. When it comes to the insulation, however, some solid masonry walls can be found narrower than 200mm. In this case, the timber stud work might need to be fixed away from the wall by 50mm instead of directly to the wall. What you need Step one: Make sure all services are installed and that all studs and rails are flush with no projections. It is common for pragmatic designers to specify an insulation fastening system that combines the attributes of both plastic fixings and steel anchors. In external wall insulation systems for low-rise buildings, the designer may prescribe the use of the more thermally efficient plastic fasteners, supplemented by using fire-safe mechanical fixing per board. Select the Appropriate Type of Non-Combustible Mechanical Fixings

Celotex insulation fixings are a perfect solution when installing rigid insulation boards in between timbers.Tip: For high thermal performance, place the unprinted foil face surface towards the air cavity. What you need: Step one: Apply a continuous band of adhesive to ensure a continuous seal is at the skirting, ceiling level and openings. Thin timber battens can replace adhesive at perimeter edges. Insulation boards by Celotex can be installed in pitched roofs, flat roofs, solid masonry walls and more. It’s easy to install when you’ve got a bit of guidance, so we’ve broken down the steps for installation in many applications.