BPDU Guard to shut down Spanning Tree PortFast-enabled interfaces when BPDUs are received, to avoid accidental topology loops. When medium dependent interface (MDI) on peer devices do not have the Automatic Polarity Correction feature, the C1000-24T-4G-L Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement1018 Position the screw template so that the edge that is marked as CABLE SIDE ENTRY faces toward the floor. Note

Many legacy powered devices, including older Cisco IP phones and access points that do not fully support IEEE 802.3af, might The interface-specific settings of the active switch are saved if the active switch is replaced without saving the running configuration.IP Phones and Cisco Aironet Access Points. The PoE switch ports are Power Source equipment (PSE) capable and source power To access an advanced PoE planning tool, use the Cisco Power Calculator available on Cisco.com at this URL: http://tools.cisco.com/cpc/launch.jsp only the software release that introduced support for a given feature in a given software release train. Unless noted otherwise, It provides you with the ability to automatically upgrade the internal flash with the USB drive's configuration and image

We strongly recommend that you attach the rubber feet. Doing so also helps prevent airflow restriction and overheating.

Features and benefits

Ethernet ports; limited PoE+ ports (PoE budget of 195W); four 10-Gigabit Ethernet SFP+ module uplink slots Remove the four rubber feet from the adhesive strip, and attach them to the recessed areas at the bottom of the unit. This the port LED turns green. If the LED is off, the other device might not be turned on, there might be a cable problem, or there IEEE 802.1X user distribution, which enables you to load-balance users with the same group name across multiple different VLANs. If you replace a failed member with an identical model, the replacement member automatically uses the same interface-specific

support with Network Edge Access Topology (NEAT), which extends identity authentication to areas outside the wiring closet (such as conference rooms).The member switch with the higher priority value retains its member number. The other member switch has a new member number. To avoid or reduce the risk of personal injury, do not use the product if the product has been exposed to irregular environmental Web authentication redirection to enable networks to redirect guest users to the URL they had originally requested. Field Notices• Field Notice: FN - 72250 - Cisco SUDI Certificate Expires When Registered to a PKI and Used to Configure Certain Functionalities on Some Catalyst Switching Platforms - Workaround Provided 22-Nov-2021

Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040 the default-interface command on the mapped ports. For more information about the command, refer to the Software Configuration Guide. In the event of discontinuance of product manufacture, Cisco warranty support is limited to 5 years from the announcement of discontinuance. Use the supplied number-10 pan-head screws to attach the cable guard to the switch. Figure 19. Attaching the Cable Guard to the Switch ports do not support autonegotiation, you can manually set the speed and duplex parameters. Connecting devices that do notThere is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with the same or equivalent Use the screw template to align the mounting screw holes and also as a guide to make sure that you install the screws into If you manually change the number of a member, and no interface-level configuration is associated with that new number, that