generally, grit bins will not be provided to service a road where it is already a primary gritting route So how can sand be a better alternative grit than silicon carbide? Well, you can make sea glass with sand. Sea glass is often found at the beach as it results from broken glass that was tumbled in the waves of the ocean. Gritting and/or snow ploughing during normal working hours - 8am to 4.30pm Monday to Thursday and 8am to 1pm Friday. Pre grit if required.

Grit bins are provided for use by local residents at a limited number of locations where there are particular problems with snow and ice - such as steps, steep roads and paths, etc. Please note that: Important principal roads, major scheduled bus routes, routes to fire stations, hospitals, ambulance depots and local danger spots on roads with high traffic levels.Depending upon surface porosity 10 litre of EXTERIOR PREGRIT will cover approximately 30 meters square Urban shopping areas and precincts. Routes to schools, health centres, hospitals, clinics etc. Main routes to residential areas. Bond-It Exterior Render Pregrit External bonding agent, a one part pre grit gripcoat paint coating. Protect adjacent surfaces from splashes and remove any EXTERIOR PREGRIT before drying using warm soapy water as later it will not come off.

Simply apply 1 coat using a brush or roller ensuring an even coat and allow to dry 6 hours minimum. Normal working hours - 8am to 4.30pm Monday to Thursday and 8am to 1pm Friday. Treatment following snow and ice. Do not use on new cement when cement has not fully cured. Do not use when the temperature is below 5 degree C.

JOIN THE BOND IT NEWSLETTER

You might also use sand as a pre-grit. Sand may also be a better variant when tumbling very soft materials such as obsidian, marble, fluorite, and calcite. Read more inour Winter Maintenance Plan or our leaflet which explains how you can Get Ready for Winter. Ploughed snow at the side of roads A one part Pre Grit paint on ready-to-use internal plaster bonding agent with added aggregate to provide a key prior to plastering. However, an exception might be in the case of tumbling very soft materials such as obsidian, marble, fluorite, and calcite. If you find the right type of sand with the proper particle size it might work. Some people use sand to place a frosted finish on tumbled glass or use it as a pre-grit.

In comparison, silicon carbide grit has a Mohs hardness level of 9+, and, as such, it is a much more effective abrasive. Sand can be used as an abrasive for tumbling agate or jasper, however, it will take a lot more time.If you wish to test a material’s hardness level, simply place it on a glass plate, add a bit of water, then place another piece of glass over and grind the two pieces of glass together. If the material scratches the glass, then it means it has a hardness level of at least 5. During periods of snow and ice, footpaths will be gritted and cleared during normal working hours. Normally we do not pre grit footpaths. Do not dilute render pre grit and bond-it recommend a patch test be carried out on a small inconspicuous area to test compatibility prior to full application. If you want to produce an abraded surface similar to natural sea glass, simply put broken glass in your tumbler and then add sand. Most natural sands have round grains shaped-particles. In comparison, silicon carbide grit particles are angular in shape and because of this angular shape, it is much more effective at producing abrasion that smooths and rounds tumbling rough into polished stones.