The throughput had a gentle fall at 15 feet, but it did go down quite a bit after going past the 30 feet limit. Full Gigabit Ports allows to Connect multiple devices with four gigabit ports and one downlink port offering PoE pass-through. They will vary due to factors including network conditions, client limitations, and environmental factors, including building materials, obstacles, volume and density of traffic, and client location.

Then, I connected three client devices, the first being a WiFi 6 computer (equipped with an Intel AX200 adapter), the second is a WiFi 5 laptop (equipped with an Intel 8265 card) and the third is the good ol’ Pixel 2 XL (also WiFi 5). Still, we’re dealing with two devices built on very different platforms (MediaTek vs Qualcomm) and, while the EAP610 seemed to have the upper hand on paper, I was surprised by how well it actually performed with both WiFi 6 and WiFi 5 client devices. centralized cloud management of the whole network from different sites--all controlled from a single interface anywhere, anytime. The logic behind this choice is for security reasons since the targeted audience for the wall units is mostly anything related to the healthcare facilities, where roaming can become a security issue.Due to its compactness, it will get a bit more warm than other access points, but I suppose it’s in line with the likes of ECW220S. Multi-person management, multi-level permissions, and the ability to add admins as needed, enable flexible network operation and maintenance. The TP-Link EAP610 and the EAP615-Wall were launched about the same time and, while they’re both AX1800-class wireless access points, they try to achieve slightly different goals.

One of the downlink ports offers PoE pass-through ‡ to eliminate the need for that extra power port. of RAM ESMT M15T4G16256A, 128MB of flash memory from ESMT (F59D1G81MB) and, as for WiFi, the access point is equipped with the Qualcomm QCN5022 802. The technical storage or access is strictly necessary for the legitimate purpose of enabling the use of a specific service explicitly requested by the subscriber or user, or for the sole purpose of carrying out the transmission of a communication over an electronic communications network.Lastly, know that the TP-Link EAP615-Wall does not support the AI Roaming, while the EAP610 does support it. TP-Link says that the EAP615-Wall should be able to power up devices that require up to 12W (or 13W in the EU). The interface is identical for all Omada devices and, as expected, the dedicated section is also the same for the TP-Link EAP610 and the EAP615-Wall.