Teknos Siloksan Façade is a water-borne, full-matt silicone emulsion based masonry paint for mineral surfaces. The paint is very permeable and water-repellent. It is free of solvents that contain aromatics. Best Uses High pH resistance (up to 12.5) for concrete, lime based plaster, plaster, stucco and fast set joint/texture compounds

This ocean blue colour is ideal for bathrooms, kitchens and bedrooms, offering a contemporary matt finish. There are also an additional 20 colour options to choose from. This easy-to-apply paint requires minimal effort to achieve a brilliant white matt finish. It has a spreading rate of up to 11 m² per litre.Surfaces should be clean, dry, sounds and free of dust, dirt, grime, grease, oil, wax, mildew, wallpaper, adhesive or any contamination that may interfere with Its convenient 400 ml spray formula makes it perfect for touch-ups and providing additional protection. Thanks to the spray application, it’s easier to apply in hard to reach areas. With a generous coverage of 13 m² per litre, and a finish that will last for several years, this 750 ml tin offers a good barrier against damp and mould. Suitable for application to new or previously painted interior walls, ceilings, panelling and other related paintable surfaces. Resistant to high pH surfaces (up to 12.5) New concrete element or cast surfaces can be painted with SILOKSAN FACADE when a minimum of one month has passed after the casting, the surface is completely bound and no longer wet or matt moist. In measurements the moisture values of the concrete must be under 97% as relative humidity (RH) or 4% as

In addition to mould and stain prevention, Polar’s matt white finish also brightens and freshens up walls and ceilings. Bright white, non-yellowing, dead-flat finish looks great over dingy, water-stained ceilings / wallsThe rich emulsion will not only provide an aesthetic finish, but it’s specially designed to be moisture and steam resistant as well – ideal for even the wettest of environments. adhesion. If unsure, always wash surface with an appropriate cleaning solution, or solvent and allow to dry out thoroughly before painting. Remove excessive chalky material and any unsoundly adhered coatings. Remove mould with an appropriate an cleaner, such as Zinsser Mould Killer & Remover. Special precautions should be taken during the surface preparation of pre 1960’s paint surfaces over wood and metal as they may contain harmful lead. When dry-sanding avoid dust inhalation by wearing a suitable protective face mask. Seal knots and sap streaks with Zinsser B-I-N primer-sealer.