DRC feature can make quieter sounds easier to hear when your radio is used in a noisy environment by reducing the dynamic range of the audio signal. There are three levels of compression: Repeatedly press and release the Band button until "AU1" or "AU2" is displayed, then AUX function is activated. Rotate the Volume/Tuning Control/Select knob to choose your desired language. Press the Volume/ Tuning Control/Select knob to confirm your setting. Select the desired waveband by pressing the Band button. Make sure the soft bended rod antenna has been well placed for best FM reception. Try to avoid operating the radio next to a computer screen and other equipment which will cause interference to the radio. Rotate the Volume/Tuning Control/Select knob until "Factory Reset" shown on the display. Press the Volume/Tuning Control/Select knob to enter the setting.

Press the Info button to cycle through the various options shown in the following letters (a. to g.). Frequency and channel Indicates the frequency and channel number for the currently tuned DAB station.Press the Advanced setting button and rotate the Volume/Tuning Control/Select knob until "Station List" is flashing on the screen. Press the Volume/Tuning Control/Select knob to enter the list of the stations. Your radio will perform a full scan of the DAB frequencies. As new stations are found, the station counter on the left side in the display will increase and stations will be added to the list. Press the Auto tune button and the radio will search and stop automatically when it finds a radio station. The radio will continue searching for the next available station unless the operator presses the Auto tune button to stop the scanning. Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. Reduced power, distortion and a "stuttering sound" are signs that the battery needs to be replaced.

Keep rotating the Volume/Tuning Control/Select knob until desired frequency is shown on the display.For preparation of the item being shipped, consulting an expert for hazardous material is required. Please also observe possibly more detailed national regulations. Rotate the Volume/Tuning Control/Select knob to get the desired sound level. The LCD display will show sound level changes.

Press the Advanced setting button and rotate the Volume/Tuning Control/Select knob until "DRC Value" shown on the display. Then press the Volume/Tuning Control/Select knob to enter the setting. The display will show the current DRC value. i have a makita ip64, i have to connect via bluetooth from a moblie phone to get the radio station working. my question is the volume only goes to 30, can this be increased as we are working in a factory.To allow the radio to find the available stations, it is recommended to carry out a full scan of the entire DAB Band III frequencies.

This radio has three tuning methods- Scan tuning, Manual tuning and Memory presets recall. Selecting a station - DAB Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Only use genuine Makita batteries. Use of non-genuine Makita batteries, or batteries that have been altered, may result in the battery bursting causing fires, personal injury and damage. It will also void the Makita warranty for the Makita tool and charger. Tips for maintaining maximum battery life Rotate the Volume/Tuning Control/Select knob to scroll through the list of available stations. Press the knob to select the station. Press and hold the desired Preset button until the preset number shown on the display, for example, "P2 Saved". The station is then stored in the selected Preset button.Connect a stereo or mono source (i.e. iPod, MP3, or CD player) to either AUX IN 1 or AUX IN 2 by audio cord. Rotate the Volume/Tuning Control/Select knob to select the following options and press the knob to confirm the setting. Stations stored in the preset memories can be overwritten by following the procedures described above. SW Version" shown on the display. Press the Volume/ Tuning Control/Select knob to view the software version installed in the radio. Rotate the Volume/Tuning Control/Select knob until "Language" shown on the display. Press the Volume/ Tuning Control/Select knob to enter the setting.