Untreated wood: should be pre-treated prior to adhesion test with an appropriate wood preserver to prevent rot and decay. Apply in dry conditions, above 5 degrees Celsius and when bad weather is not forecast, minimum of 2 coats required. The final colour will vary depending on the surface and number of coats. If adhesion is inadequate on previous coatings, lightly sand before application. Make sure wood has been pre treated with appropriate wood preserver to prevent wood and decay. Test a small area first for colour and adhesion: Colour the final colour will depend upon the type of surface, previous treatment and number of coats applied. If using more than one can it is advisable to mix them together in a container or finish in a corner before starting a new can. Adhesion: if adhesion is inadequate on previously coated surfaces, lightly sand before application.

As Garden Shades often goes on directly to the wood, without a primer, sometimes it will soak deep into the wood and this can create the need for a third coat. This may be noticeable with rougher woods, open end grains or indeed deep colours. If wood has been exposed and dried out for a long period of time, this may also draw the more of the product away from the surface and into the wood structure. Be mindful that it is waxed-enriched and that once these waxes are dried, they act to repel liquids, which would include an additional coats. Don't try to coat the whole project with one coat before getting onto the next coat. Instead it is better to paint sections in in time chunks of 2-4 hours. Stir thoroughly before pouring contents into a Cuprinol sprayer. Overspraying surrounding areas can be minimized by avoiding spraying in windy conditions and by using cardboard or plastic as a shield. Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent. MINIMUM OF 2 COATS REQUIRED. SUBSEQUENT COATS MUST BE APPLIED ON THE SAME DAY NO LONGER THAN 8 HOURS APART. IF NOT POSSIBLE, LIGHTLY SAND DOWN SURFACES BEFORE RECOAT TO ENSURE ADHESION.