Our mortar rakes comprise carbide tungsten cutting strips (we refer to them as ’cutters’) brazed onto a steel core, which is secured in a hex-shaped holder, having an internal M14 thread to match that of an angle grinder spindle. A 3 cutter rake will cut most aggressively so will be best for soft or crumbling mortar. By contrast, it is likely a 6 cutter rake will provide smoother operation on harder mortars, even though it may not cut any faster. Dust extraction – permanently-open 32 mm extraction port with ‘keyhole’ extension in base-plate for enhanced cleaning of the raked joint Termite Mortar Rake angle grinder attachment with short 32 mm extraction hose and vacuum connector (see product images) The Termite Mortar rake attachment clamps to the machined collar on the angle grinder. Nylon spacer rings compensate for the variations found across the range of compatible angle grinders. A 5 mm allen key is provided for tightening the clamp. The attachment can be positioned freely in relation to the grinder, to suit the preference of the user.

Construction – steel fabrication with hard-wearing STAINLESS STEEL base plate (with bevelled edges and sighting guides) With use of a powerful shop vac, I was hoping for almost no mess, approximately 40% of debris and dust still got past & a dust mask had to be used. The tool is compact but makes an angle grinder a little clumsy and awkward to manipulate, but it is not priced as if high tolerance engineering, perfection wasn't expected, but it was still a little disappointing. With exception of items listed below the Termite attachment will fit most Bosch, Hikoki (Hitachi), Makita, Metabo and DeWalt 115 mm or 125 mm angle grinders. We CAN NOT vouch for any other make / model of angle grinder.the Termite attachment WILL NOT fit GREEN Bosch 115 or 125 mm grinders - green-bodied Bosch grinders are non-professional products