Available in the following matching color profiles: Charleston, Huntington, Hunter, Giles, Aspen, Horizon, Meridian, Cedar Branch, Reveal, Monroe, Misty and most other P-Series profiles. Not all galvanized is created equal, pre-galvanized steel does not perform as well as HDG. Galvanizing after production ensures all areas of the steel is uniformly coated with zinc. The same process used for national highway guardrails, an area subjected to some of the harshest environmental conditions. We source our timber from companies that are FSC registered, and get their timber from sustainable renewable sources. Accessories available to finish your project; Trim Ring Stones, Pyramid Caps, both available in brown or gray. Post bases do not provide adequate resistance to prevent members from rotating about the base and therefore are not recommended for non-top-supported installations (such as fences or unbraced carports).

The ABU66Z provides a 1” standoff to get your 6x6 post 1” off the ground. Not only will your project be code compliant, but it will keep your post end from sitting in standing water to prevent unwanted rotting and damage. Please note, 6″x6″ post surrounds are intended for a post measuring approximately 6″x6″ (Posts larger than this will be too large for the post surround product to wrap around the post accurately). NOTE: The correct fasteners installed in the correct position must be used to achieve published load values Pressure treated 6×6 post. This 6×6 timber post is suitable for use in agricultural and landscaping. As with all Oakdale Fencing products, the timber is sustainably sourced and of very high quality. The top of the timber post has a four way weather top. This tanalised 6×6 post has been pressure treated as well as being naturally robust and durable. The G185 ZMAX ® galvanized finish provides a level of corrosion resistance that is acceptable for use with treated lumber and normal outdoor use. If you’re installing in a high corrosive environment, i.e. near saltwater or where exposure to chemicals may occur, it’s recommended that you use a stainless steel base like the ABU66SS Stainless Post base.Post bases do not provide adequate resistance to prevent members from rotating about the base and therefore are not recommended for non top-supported installations (such as fences or unbraced carports). Many of these products are approved for installation with Strong-Drive® SD Connector screws. Model No. Uplift loads have been increased for earthquake or wind loading with no further increase allowed. Reduce where other loads govern. You don't have permission to access "http://www.lowes.com/pd/Simpson-Strong-Tie-Steel-G185-Post-Base-Common-6-in-Actual-5-in/3044772" on this server.

Shims are required for double 2x (1 shim) and triple 2x (2 shims) installations as shown in the illustration. Additional fastening of shim to beam is not required. stand-off design meets code requirements for structural posts installed in basements or exposed to weather or water splash At OZCO our passion and love is to manufacture the highest quality building products from Decorative Hardware to PostYou don't have permission to access "http://www.homedepot.com/p/Simpson-Strong-Tie-ABA-ZMAX-Galvanized-Adjustable-Standoff-Post-Base-for-6x6-Nominal-Lumber-ABA66Z/100375370" on this server. With over 40 Years experience in the fencing industry the name of Oakdale Fencing Ltd is synonymous with quality, value and service.