GRAVITY FED SYSTEM: The CT60 Bathroom is only compatible with gravity fed systems, which means a system in which there is a hot water cylinder in an airing cupboard and a large cold water tank in the loft. It is important to choose a pump that is compatible with the system in your home, as incorrect selection can mean the pump will not work. For example, if you gathered 600ml in 10 seconds, to calculate the flow rate in litres per minute – 600 x 6 = 3600ML per minute = 3.6L/min. With its WRAS approval, Quiet Mark award, and 3-year warranty, the Salamander HomeBoost inline pump is a reliable and efficient choice for improving water performance in your home. Installation Process and Compatibility

The pressure to my house is very low which affects my shower pressure . The pressure is between 0.6 and 0.8 . Would this pump being fitted rectify that and get my shower to consistently work ? Especially at peak time ? The pump should be fitted directly into the incoming mains supply either just after the stop-tap or just before the combination boiler. It is advised to position the pump near the stop tap, installing either vertically or horizontally, but never upside down. Ensuring there is adequate airflow to cool the motor, and ensuring that it is separated from any other appliances that generate heat. Installation If you live in an older property there’s a good chance you have a gravity fed system, renowned for poor pressure and flow.SUITABLE FOR USE IN WHOLE HOUSE: When selecting the right pump for your home, it is important to note that you can go up the range, but never down. For instance, a whole home pump (e.g. CTForce 30PT) can power a shower alone, but a shower only pump (e.g. CT50 Xtra) can NOT power a cistern, taps, whole house etc. The Right Pumps 75TU pump is compatible with whole house applications, such as a bath, electric shower, wash basin, and washing machine.

Now, you can introduce the pump into its location and gently connect it to the pipework. 5. Turn the mains water on As part of The Water Supply (Water Fittings) Regulations (1999), incoming water supply can be pumped to achieve up to 12 litres per minute, hence that being the regulated maximum output of the Home Boost. They are manufactured in the UK using top quality parts which are mostly supplied by the EU. The parts are extensively tested to ensure a long lasting and reliable product.In conclusion, the Salamander HomeBoost Inline Pump is a smart and reliable solution for low water pressure in your home. Its intelligent design detects and boosts flow only when needed, ensuring optimal performance and energy efficiency. Installing a Home Boost is not particularly difficult. With a few tools and some DIY knowledge, you can easily install the Salamander Home Boost without hiring a plumbing or heating engineer. Installation diagram CT Bathroom pumps have been designed specifically to meet the demand for increased water supply to the bathroom. With positive head and negative (universal) head models available in 1.8 or 2.6 It’s important to note that the Water Supply and Fittings Regulations state that you can only pump the mains up to 12 litres a minute, so this pump is designed to switch off if your flow rate exceeds this and is therefore designed for circumstances where the mains water pressure is extremely low. There are still solutions available to households that need a higher flow rate than this, but they involve storing mains water, so take up significant space. SUITABLE FOR USE WITH BATHROOM, EN-SUITE, OR UTILITY ROOM: When selecting the right pump for your home, it is important to note that you can go up the range, but never down. For instance, a whole home pump (e.g. CTForce 30PT) can power a shower alone, but a shower only pump (e.g. CT50 Xtra) can NOT power a cistern, taps, whole house etc. The CT60 Bathroom pump is compatible with a whole bathroom, such as a shower, bath, cistern, wash basin, and tap, to boost both hot and cold water.