Free-standing installation: The base of the alarm has been designed to allow it to stand freely on a shelf where required. Once your CO alarm is activated, this icon or ‘heartbeat’ will continue to flash a green LED in power mode. If a battery fault or warning has been silenced for a period of 8 hours and times out during night time, the silence period will automatically be extended once for a further 8 hours (night silence will increase the counter by 1 for sleep easy). Please note, this feature is not available with the FA3820 or FA3313 alarms. Understanding FA3322 digital display indicators Combined smoke & CO alarms or mains-powered CO alarms are typically installed on the ceiling and should be at least 30cm away from any wall, light fitting, or other obstruction.

attaching the base plate. After 1 minute, press the test button to hear the alarm sound. Please note, the alarm will not sound before the 1 minute activation period is complete. Night sensing lowers the brightness of alarm’s heartbeat sensor and automatically activates ‘sleep easy’ mode, allowing residents to silence low battery chirps for 8 hours, up to 10 times. Carbon monoxide alarms in rooms with sloped ceilings should be located at the high side of the room. Following amendments to the Smoke and Carbon Monoxide Alarm (England) Regulations 2015, since October 1st 2022 a carbon monoxide alarm is now required in all rooms where there is a fixed combustion appliance – such as gas boilers or gas fires – once the compliance date is announced. However, gas cookers are excluded from the updated regulation. To activate a new CO alarm, pull the disabling tab out of the device and wait up to 1 minute for the green LED to flash to confirm the alarm is active. For the FA3328 only; activate the device by

With a multi-functional LCD digital display and array of exclusive features such as Alarm Memory, Ventilate Instruction and Environmental Sensing, the FA3322-EUX10 offers the highest level of CO detection for a property. Tenants can experience both audible and visual safety warnings with the digital screen, which displays temperature reading in standby mode and highlights dangerous temperature and humidity conditions to encourage intervention. The display also changes colour to indicate various warnings to residents for clear safety advice. Landlords must also repair or replace alarms when notified of a fault, but regular alarm testing will remain the responsibility of the resident. The smoke and CO alarms must comply with BS EN 14604 (Smoke) and EN 50291‑1 (CO) and carry a British or European approval mark, such as a Kitemark. https://www.fireangel.co.uk/wp-content/uploads/2022/10/MA0394R1-FireAngel-CO-Icon-Guide-Blog-Assets-Identifier-Guide-Draft-1_Power-Nightime-Sensing.mp4 Ideally, an alarm should be installed in every room containing a fuel-burning appliance and every sleeping room. Additional alarms may be installed to ensure that adequate warning is given for occupants in other rooms, in which they spend considerable time whilst awake and from which they may not be able to hear an alarm in another part of the property.

If your alarm is not a sealed battery alarm, then install the batteries following the steps within the manual. Please note, only the sealed battery CO alarms, including the FA3820, FA3322 and FA3328, are suitable for homes in Scotland under the new fire and CO regulations. WARNING: This alarm will only indicate the presence of carbon monoxide gas at the sensor. Carbon monoxide gas may be present in other areas. Where should I position the CO alarm? Do not install CO alarms within 3 metres of doors or windows, above radiators, or immediately close to anything that gives off steam or fumes like a cooker or shower room. Similarly, it is not recommended to install detectors in dusty areas such as workshops or garages.Battery powered carbon monoxide alarms can typically be installed wall-mounted or left free-standing on flat, level surface.

Find out more about the FA3820-EUX10 CO Alarm. FA3313-EUX10: Carbon Monoxide Alarm with 1 year replaceable batteries The alarm features the latest CO sensing technology and can be used to replace end-of-life FireAngel CO-9X alarms. Fitted with a sealed, tamper proof battery that will last the lifetime of the alarm. The sensors within the unit will deteriorate after 10 years, so to ensure you’re protected we recommend you replace the unit after this time.Once your CO alarm is activated and tested, choose to install the alarm by mounting on a wall or free standing on a shelf. Your alarm should be placed 1-3 metres away from any fuel burning appliance in your home, in living rooms or bedrooms. The FA3820-EUX10 Carbon Monoxide Alarm offers a variety of safety features, including Ventilate Instruction, Alarm Memory, Sleep Easy and Quiet Self Test. Find out more about the Smoke and Carbon Monoxide Alarm (Amendment) Regulations 2022 to ensure you are compliant. Achieve compliance with Smoke and Carbon Monoxide Alarm (Amendment) Regulations 2022