Surface preparation required in addition to the above – clean with Frenchic Sugar Soap, rinse and dry thoroughly. Hand-sand sufficiently to abrade the surface. Wipe off any dust, paint away! For a great demonstration, see our video.

When painting your radiators, you shouldn’t use normal, everyday paint unless you’ve applied a proper undercoat and are painting on the correct type of radiator. When choosing a new radiator it's important to know what heat output you'll need for your rooms. To work this out easily we have created a handy radiator calculator to help work this out. Avoid painting in direct sunlight, only when the air and surface temperatures are between 10 oC and 32 oC and humidity is less than 85%. Do not apply if, in the following 48 hours, there is likelihood of rain, frost, fog, condensation or if the temperature is likely to drop lower than 10 oCFor the best coverage around the curves of this fixture, prime and paint a radiatorusing cans of spray paint.Choose an oil-based aerosol primer and either an oil- or water-based paint that is labeled for interior use on metal surfaces.Depending on your radiator,look for the following attributes:

If you want a clear coat, some experts suggest using polyurethane and the best finish by far is achieved with spray paint, both in terms of durability and consistent appearance. A high-temperature paint can be used, too, but it is not absolutely necessary as the temperature of the steam is within the working range of most spray paints. Clear Radiator Overcoat: If you really want to paint your radiator with an everyday emulsion then you should use a clear radiator overcoat on top. All you need to do is choose your colour, paint the radiator (It may need more than 1 coat of paint) and then apply the overcoat on top. This will give your radiator a smooth protective coating. Is Primer Needed Before I paint? For this reason, it’s better to know which paint to apply to a heating system for the best results. If you do choose to go ahead with normal paint, be sure to apply a “clear radiator overcoat”. Some experts recommend this for cast iron radiators and steel radiators. In particular, using a specialist radiator primer or metal primer will give your paint a proper surface to bond to and will stop rust with its anti-corrosive properties. Porous, or ‘thirsty’ surfaces like bare wood or MDF, tend to absorb paint meaning additional coats are likely to be required to achieve a durable finish. In this case, your 750ml tin will provide less than 6m 2 of full coverage. If you apply the paint too thinly, durability may be affected. Finally, don’t use a latex spray… it will not provide a tough enough finish. Instead, we recommend gloss oil as the best option.Metallic paint formulated for multiple surfaces. Suitable for most types of furniture, laminate, powdercoated radiators, UPVC, ceramic wall tiles (we recommend avoiding very wet areas like shower/bath surrounds), plus wood, concrete and laminate floors with correct application – please note that maintenance may be required in these situations It’s important that you prime the surface of your radiator before you paint it and for that, you’ll need to use a specialist radiator primer. This step is imperative as it will ensure that bare and rusted areas of the radiator are protected and won’t be interfered with. Priming your radiator will also give you a great base for the coats of paint and will mean you’ll have a nice smooth finish. If you find that your radiator does have a few rust spots you should definitely invest in an anti-corrosive primer because this will really help to prevent the rust from getting any worse and doing some terrible damage to your radiator. You don’t need to use a fancy paintbrush when it comes to applying your primer, a normal everyday paintbrush will do. If you really want to access the awkward areas of the radiator you should definitely get a specially angled radiator brush as this will make painting those difficult to reach areas easier. Painting Radiators

Painting radiators is much unlike any other household painting job. It just isn’t the same as painting walls, skirting boards or even doors: there is a lot more to it than that. When you decide to paint your radiator you will have to plan carefully to make sure you don’t mess the job up. If you mess up this paint job you could end up with a radiator which has lots of terrible looking air bubbles and you might even have to spend quite a bit of cash correcting the mistake. In this article, we will go through a step by step guide on how to paint your radiator in the best possible way. We will look at what you will need to paint your Anthracite Towel Radiatorand also talk about what type of paint you should use. When it comes to painting your radiator you must never think you can use normal everyday paints like the ones we use for our walls. These paints whilst good, are not heat resistant, lose their colour over time, and may even give off an unpleasant smell. There are however some other great options you can choose from, and it all depends on what is suitable for you and what you can afford. Don’t skip this step! It’s the key to long-term coverage that lasts. Without this step, your radiator could be prone to rust and have a dull, lifeless finish. There are a number of heat-resistant radiator paints on offer, both in the form of paint tins and in aerosol cans for spray painting. What kind of paint do you use on a radiator? Exterior wooden surfaces in particular can retain moisture for up to 48 hours after rainfall or preparation. Ensure the items are thoroughly dry prior to painting. Scrape a small, inconspicuous area on the radiator surface with a screwdriver blade and look for flaking to confirm whether or not it had been previously painted or varnished. If there’s no flaking, go over any pitting from heavy rust with coarse-grit sandpaper (e.g., 40- to 60-grit). Then sand all surfaces with fine-grit sandpaper (e.g., 80- to 120-grit) to remove light rust accumulations and achieve a smooth, paintable surface.Reseal tin after use. Clean up any spills immediately with water. Wash brushes in warm, soapy water. So why go gold? Gold radiators are not only a sign of luxury, but can be a subtle colour to blend into your interior as well. With a wide range of colours tones to explore, gold needn't be an extravagance and can suit almost any interior if you get the tone right. With its calming brightness and subtle brown shades, gold is one of the most unique colours out there and can really make a radiator stand out from the crowd, embellishing your home with extra flavour and character.

A straightforward metallic look is often most pronounced when the product is applied over a base similar in colour to the paint. A 500ml tin will provide a single coat of up to 8.5m 2. For a durable finish, a minimum of 2 coats is required, so your 500ml tin should provide full coverage for just over 4m 2 on non-porous surfaces. What's more, there are plenty of radiators out there which can have their look lifted by the colour gold. Take the vintage column radiator for instance. Cast iron radiators look fantastic with a golden finish. Dark gold perfectly suits column radiators, whilst properties may also benefit from the more gaudy end of the spectrum, where gold designer radiators become focal points and characters within themselves when placed in your room. Whatever you go for, the gold radiator will always bring joy into your home. The metallic mineral pigment content of the Frenchic Metallics range makes it a bit different to our other paints. The finish will naturally look hand-painted due to its metallic gleam as well as the nature of the mineral content – in other words, some appearance of texture is to be expected. This means it is great for a huge range of effects. If, however, a super-smooth or uniform finish is desired, the product can be sprayed by adding a little water. If you want to paint a radiator that is non-operational,both the primer and paint that you use should be rust resistant.

Spray Paint: Some people choose to spray paint their radiator, but you’ll probably want to remove the radiator from the wall before you start. Painting your radiator this way will almost guarantee a tidy clean finish, and there are no drips or spills to worry about with this method.