The tool’s extended length makes it easy to visualize the blade alignment with the fence and the miter slot. As mentioned, blade wear or use beyond the reliable life of the cutter will result in tracking issues and there are all sorts of ways (including an expensive fence) to handle that until your new blade arrives. I set my wheels co-planer, I flutter tension my blade, I align my miter slot (table) with the blade. The design for a wide blade application could be improved if it were longer, as you still need to do some test cuts, which might defeat the objective if one had an extremely trustworthy saw. There are many opinions on this subject but there are also objective facts and laws of physics/geometry that can't be ignored.

com/p/ujk-bandsaw-buddy-blade-aligning-rule/101807 101807 UJK Bandsaw Buddy Blade Aligning Rule https://www. Once on, it will follow the blade alignment allowing you to adjust the fence to it's angle or whatever you want to set it at. The Companion is also an accurate rule, has a sliding stop for setting distances, and can be used as a beam for scribing circles. Mine is VERY slightly curved as you can see in one fo the photos but it's an even curve so I can get away with it by simply looking at each end. For aligning the fences for parallel cuts, the 250 mm long Bandsaw Buddy is attached to the saw band via integrated magnets, and serves as an extension of the saw band width.With holes spaced every half-inch, you can also use the tool as a compass to draw circles up to a 23" diameter for bowl blanks. Your post touches on a lot of areas but it seems you have found a method that works for you so I would stop there. This way a person could move the pin to the opposite end of the ruler when using it as a stop ruler.

And not in the hands of the 3D printing or software giants who own the competing platforms and exploit the designs for their own commercial interests.Medium size band saw with 300 mm cutting height and 310 mm cutting width (345 mm without rip fence). Timbecon is passionate about reliable and affordable products that will get you into woodworking today.

In my experience though, the main source of drift is the blade itself, I had a blade that drifted badly, I sharpened it with a Dremel and metal cut off wheel and the drift is gone. In our opinion, first-class tools are defined by haptics, ergonomics, material and manufacturing quality. Unfortunately what works for 'you' becomes gospel despite minimal or even no actual testing against a control of some kind. make sure the teeth of the blade go in the slot so they do not kick the bandsaw buddy off to the side. Not sure if its doing the same as that but I made up a stick with two magnets and capped it in brass sheet as a fence as I have no fence of any sort on my medium bandsaw with 20 inch wheels.Its a good useful thing for quickly sticking it down at whatever distance off the blade for when I want to cut multiple lengths of dowel or pegs .

So, not to sound like a jerk but why would I fiddle around with things that aren't designed to be adjusted?

Brand New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging . This visibility then allows alignment of the fence and miter slot with the blade, and the built-in rule also makes it easy to set the fence an exact distance from the blade for saw cuts. It also has a couple of magnets on it midway so you can stick it to a bandsaw blade to help align your fence.