but the Bambu’s first layers are so perfect that I’d rather use a good adhesive to help stick it on than to reduce the quality of the initial layer. AMS Technologies’ liquid to liquid thermal management assemblies are ideal solutions for cooling large power electronics or energy storage systems using process water.

Plates | Q ATS Cold Plates | Q ATS

Dependent on the required thermal performance and the cooling fluid to be used the tube can be copper or stainless steel and can be a simple mechanical (dry) press fit, press fit with a thermal epoxy boundary to eliminate micro voids or soldered in place for maximum thermal performance. The 609mm Exposed 6-Pass Cold Plate Heatsink from Wakefield Thermal allows for greater flexibility when it comes to cooling because it offers numerous flow paths for various heat source locations. Since the bath is a flux, complete bonding on oxide-free surfaces assures unusually high quality joints.

With the installation of the 304mm Buried 4-Pass Cold Plate Heatsink from Wakefield Thermal, you receive the ability to maintain full control over the operating temperature of the device. This option provides greater flexibility, but the thermal performance is limited because of the surface area of the tube perimeter. Looking at the hours on my Bambu as reference, I have only been using the VM product for 150+ hrs of printing and I am still learning. For toys that I print for myself or the kids (kids are really into Pokémon right now) I do not clean the plate or recoat with more VM and I am mostly using PLA.

cool plate : r/BambuLab - Reddit Compatible materials for cool plate : r/BambuLab - Reddit

Possibly the simplest form of cold plate where a joint free tube is embedded into a copper or aluminium carrier. ATS has the products needed to design a complete liquid cooling loop : Cold Plates to transfer and remove the heat from the source; Heat Exchanger to tranfer heat from the liquid to the air with or without a fan; and Chillers to circulate and condition the fluid in the system. A gun-drilled cold plate is manufactured by drilling a series of holes through the length of an aluminium plate to form multiple flow paths. The 304mm Exposed 6-Pass Cold Plate Heatsink from Wakefield Thermal offers minimum thermal resistance between the electronic device and the cold plate for greater thermal performance. Columbia-Staver can also offer FSW (Friction Stir Welded) cold plates, Vacuum Brazed and Dip Brazed.If you are looking for complete thermal management solutions rather than components, AMS Technologies provides an exceptional portfolio of ready-to-use liquid to air thermal management assemblies like our range of recirculating chillers, ambient cooling systems and other liquid to air thermal management solutions, using water or water-glycol mixtures for heat transfer. We’ve seen some great examples of these over the years, such as plates ending in GYM for a gym owner, RUG for a carpet fitter, LOO for a plumber, LOX for a locksmith, PUB for a landlord and much more.