Caution — a relatively large number of users have complained that this battery will degrade / lose capacity, or outright stop working, after a number of months. But then again our little scale 4 x 4 cars are not super power hungry when driven normal, but you can get in a bind where you can use huge amounts of power to get out or snap a 5 mm hardened steel axle.

Extended recording times - NEO 5 is capable of powering a standard single channel dash cam for over 22 hours of constant recording (dash cam model dependant). In real-world situations where the dash cam is only recording periodically, when motion or impact is detected, the operation time can be measured in days rather than hours My friend laughed at me cuz my car was beefed up with all steel and ALU housing gearbox, but his plastic gearbox also needed heat to get going again. TBH a ready to run lipo like that i would assume it have some form of BMS build in, if not the charger should have that, and i assume this also go for temperature and not just balancing like a lipo charger for flashlight or RC batteries ( though a few do have a temp probe ) The "Cellink Neo" functions like this in use and is very popular with dashcam users, but it too has some things to be aware of. First is price- it ain't cheap. Second is that even in it's 'fast charge mode' you still need about a 45 minute drive to fully charge it (slow charge mode takes a few hours). And there have been some apparently random reports of units dying far earlier than they should but overall it's not too bad. You can add the B-124 battery extender to this for longer runtimes

The battery inside a dash cam is not meant to actually power the camera unit to run on its own, a dash cam is meant to get constant power from your car or a power bank. The only purpose of the battery in a dash cam is to have just enough power to save the last video file when you turn your car off. This is why more and more dash cams don’t even have batteries and instead use a capacitor, which does far better in high heats. ******More info on the difference between a battery and a capacitor in a dash cam. Can you replace your dash cam battery? As a protection against overheating, the device will stop charging if the battery’s temperature approaches or exceeds 80°C / 176°F. NOTE: Take the “parking mode duration” advertised by manufacturers with a huge grain of salt. Battery duration varies greatly depending on the model of dash cam you have. If you know your camera’s power consumption in mA, you can calculate exactly how long the battery will last: Just divide its capacity by the power that will be consumed. Having the correct dash cam cable clips to keep your cables tidy and secure is essential to make sure the dash cam cables are not flapping around and distracting you while driving.

Best all around battery bank for all brands of dash cams like VIOFO, Garmin, Rexing, APEMAN, Anker ROAV, KDLINKS, AUKEY, Vantrue, Street Guardian and more. Thinkware say that a 2-channel dash cam will run 27 hours on a full charge in Motion Detection Parking Mode, and up to 40 days in Thinkware’s Radar Assisted Parking Mode. This is a parking mode unique to the Thinkware U1000 and U3000 models, which are the only dash cams that support radar. Built-in Bluetooth allows you to view charging status, amount of record time and more directly on your smart phone.The iVolt Mini requires a direct connection to an accessory-switched 12v DC power source, ideally the vehicle fuse