I would highly recommend the GodHand SPN-120s to Gundam modellers who want to improve the quality of their builds - but obviously you do NOT want thes e Nippers as your sole cutting tool - they should be an addition (and super important) to your Gundam building tool kit. There also consider the durability of our customers to focus on next sharpness degradation of sharpness.

Left blade is playing a role to suppress the thing off. Then, sputtering in the blade and cut right. Poor lubrication of moving parts causes wears on the shaft and rattling, leading to reduced sharpness. Please lubricate the moving parts regularly. Searching Reddit’s r/gunpla/ community the other day, I saw a post titled “ What’s the single best nipper after God Hand?” To this poster, the fact that the God Hand Ultimate Nipper is undeniably number one on the nipper ranking isn’t up for debate. All in all, the GodHand SPN-120 is an amazing tool and a must-have for anyone serious about Gundam or models in general. 5 out of 5. Usually, when I cut pieces out of the sprue, I leave a small nub that I can then cut off with an X-Acto knife. But the God Hand is so sharp and narrow that it can get right up against the part, allowing me to skip the knife step. With the God Hand, my process is this:Single Edged Structure is where one blade is the “Cutting Edge” and the other blade is the “Cutting board Edge”, like a knife and a cutting board.

Having said that, when you use the GodHands correctly, you get a smooth cut with a miniscule amount of white plastic in the middle of plastic piece or runner.Most of the products shown are beingcolored manually, there may be some uneven colorings. Color and form of the product may differ from the actual product and what is seen on screen depending on monitor settings. Some product imagesshown may be in development stage. They may differ from the actual products. What makes the God Hand so maneuverable? Well other than their dangerous sharpness, they also have the shortest and slimmest blades of any of my side-cutters. NOTE :หากสั่งสินค้าพร้อมส่งกับสินค้าพรีออเดอร์ในบิลเดียวกันจะรอจัดส่งพร้อมกันเมื่อสินค้าพรีออเดอร์มาครบแล้วนะคะ Compared to a standard nipper, the section that is cut has a clean surface which is beneficial to those who want to finish the plastic models without painting.

The blade is thinner toward the tip and is more likely to break. Please cut as close to the center of the blade as possible. The standard force for cutting 3 mm dia. plastic is 2 kg or less. (General nippers are 3.5 kg to 10 kg) Being the nerd that I am I took them both to my wife and had her use the Tamiya snips first, no problem, they worked as expected. Then I handed her the God Hands and had her do another cut; her response was "wow!". She then proceeded to cut the rest of the sprue into bits just because it is amazing how easy it is to do. Literally like as close to zero resistance as you can possibly get in a world subject to the laws of physics.

Brand

The sharpness of the cutting edge achieves a smooth cut surface as if sharpened with a design knife and minimizes plastic whitening (a phenomenon in which the cut section turns white).