Like the 144001, the suspension geometry is very well sorted, simply because it has been copied directly from the excellent LC racing EMB-1. The big, heavy brushed motor in the 144001 made the weight distribution very much rear biased though and this overloaded the rear suspension and caused balance issues through corners and obstacles that made it feel a little uncomfortable (although this was largely disguised by the quality suspension). If you are wanting to upgrade or simply want to read about it, I have published over a dozen articles on 144001 upgrades which are relevant to the 124019 and will also be writing some 124019 specific articles shortly. For now, all of my 144001 articles are here: Upgrade 2.4GHZ Receiver + 2.4GHZ LED Transmitter (This upgrade Transmitter and Reicer board must be used together. ) The remote control car produced by the original factory does not support a 3S battery and will burn out. If you have to modify the 3S 11.1v battery, you need to upgrade the receiver board, remote control, motor, and ESC, steering gear. use. Question: Since this has an upgraded battery included, is it premodified to fit the larger battery? or do we still need to modify it ourselves? Most of the equipment of this remote control car is waterproof, which can drive in less watery terrain. At that time, if the water is too deep, try to avoid using it. Avoid the battery plug, etc., from touching water and burning the remote control car. Question: How long is it usable until the charge?

With the 124019, the extra length has been well utilised - particularly with the battery moving forward to offset the rear biased weight from the motor. Now weight split is close to 50/50 and this means it is much more balance on the straights, through corners, over jumps - everywhere. What this means in real life is that the car feels really predictable, even when grip is low. This remote control car can support a 7.4V lithium battery by default. As long as the size can be put down or fixed, you can use a larger capacity lithium battery. Note that the discharge factor is preferably 15C, the voltage should be 7.4V, and the material should be lithium battery. Question: what is the size of the battery compartment? what maximum size of the lipo battery does it takes? up to lipo 2s 60c 6000mah?This remote control car has a total length of 35.6cm, a width of 20.8cm, and a height of 12.3cm. The outer color box size is 45.6*22.7*14.1CM. Answer: This upgrade Brushless set we have test ,we suggest use 2S battery , if 3S battery will too hot ,and the motor or ESC maybe burn 3) Max speed for this upgrade Brushless set ? The original remote control car comes with a lithium battery inside. It has been installed in the remote control car, you can directly connect and use it after receiving the goods. Question: what spare batteries do people recommend for this car.

Answer: about 70km/h These Parts are used for the EXPLOROR WLToys 124019 RC Car Buggy, EXPLOROR WLToys 1/12 High-Speed Racing Car Because the remote control car is made of alloy + PA material, the whole car has first-class anti-collision performance and good internal seismic performance, which can greatly protect the normal operation of various internal circuit equipment. Wltoys 144001 1/14 4WD Alloy 60km/h High Speed RC Buggy Electric RC Car ,Wltoys 144001 1/14 Parts,Wltoys 144001 RC Car Parts Product parameter Product accessory details: manual, charger, small cross sleeve Product function and feature introduction: