COMPLETE SAFETY - You can sleep peacefully knowing that the Nanny Monitor monitors your baby's breathing and movements while he sleeps. You will be informed when your baby's breathing falls below a dangerous threshold. The linking icon will appear on the screen until the "Successful Pairing Icon" appears on the screen: and you can now continue with step 5 Install the sensor pads under the mattress. With the printed side facing up, place the sensor pad under the crib's mattress in the middle of the crib. No bedding should be between the mattress and sensor pad. Secure the sensor pad using a tie wrap. The cord of the sensor pad should pass beneath the mattress and run along the floor so that it will be out of your baby's reach.

Looking for similar products? See the best baby monitors with audio and video options for every budget, with every item tested by real parents. How good is the audio quality? The sensitivity of the Sensor Pad CAN be adjusted to suit most different sleeping situations. There are more topics on this in our Help Centre, simply search for "(**your model**) Four Corner Test" for to get started. You can switch the viewing camera by using the View Mode button on your Parent Unit. Just select the Nursery Unit 2. After 20 seconds a series of continuous beeps (The Main Alarm) will sound from the Nursery/Camera Unit & Parent Unit.If the connection has been made, the Green Successful Pairing Icon will appear on the screen and the menu will show the OK Paired Icon . This process can take up to 15 seconds. Note: If you have two Sensor Pads, you will need to remove the battery from both of them first and then follow the steps below Press either UP or DOWN button on the Parent Unit (underneath the screen) until you see the “Tic Function (Pendulum), Sound Function (Speaking face), Movement Function (3 wavy lines) Icons flashing in the top right hand of the Parent Unit screen Install the parents' unit. Connect the AC adapter to the parents' unit and plug the other end into an electrical outlet. Insert the batteries included with the unit. Allow the unit to charge for 15 continuous hours before using the monitor, according to the Angelcare monitor instruction manual. You can switch the viewing camera by using the View Mode button on your Parent Unit. Just select the preferred Nursery Unit or the split view.

Set the sensitivity of your monitor to the lowest setting. Ensure the Sensor Pad is placed in the middle (centre) of baby's sleeping area. Switch on all units (Nursery and Parent) and step away from the cot. After 20 seconds an alarm should sound to indicate that no movement has been detected. You will see the Sound Function (Speaking face) Icon flashing in the top right hand of the Parent Unit screen: If the alarm does not sound when you step away from the cot reduce the sensitivity down a single level and repeat the 4 Corner Test. Keep adjusting the level until the alarm sounds ensuring that movement is still detected in all four corners We understand the appeal of a one-and-done solution and see why parents will be drawn to this monitor. However, we think there are better, easier-to-use monitors in our best baby monitor review. Its performance in every testing metric makes it an overpriced option that does nothing very well. What Other Movement Monitor Should You Consider? LARGE SENSOR - The Nanny BM-02 sensor has a large surface area of 30 x 50 cm so that a large area of the bed can be monitored. Place the sensor under the mattress. Remember that for proper operation the sensor must rest on a flat, rigid surface (a bed with slatted frames is not suitable).Our tester raved about the monitor’s audio quality and loved being able to hear her baby breathe. Is the picture quality any good? Hollow Framed Mattresses are mainly found in the US, they contain a number of poles that are fitted together with a tight cover fitted. As a result of there being nothing inside the mattress (i.e. hollow), no movement is transferred down to the Movement Sensor Pad. As a result, the monitor may false alarm indicating that baby's movements are not being detected by the Sensor Pad. Please Note – if you do not wish to hear the movement TIC through the Parent Unit indicating that baby`s movements are being detected do not highlight the Tic Function (Pendulum) Icon