For the past 6 years, I have carried around a number of different multitools and used them for every purpose under the sun. I personally carry around a Gerber Center Drive whenever I leave the house. It’s super useful, has a bunch of tools, and feels awesome in the hand.

Gerber is very clear on who they intend the Center Drive for: Contractors, electricians, plumbers, and construction workers in general. It’s a heavy duty multi tool with a focus on building specific tools. Many of the most common functions included on multi tools are missing from the Center Drive to make room for its main tools. The Leatherman Wave Plus and Gerber Center-Drive are two popular multi-tools. But what are the differences and similarities? What are the advantages of both tools? And why would you choose one over the other? We will explain. Gerber Center-Drive vs Leatherman Wave PlusAs far as decoration goes, this is a nice looking tool. Gerber does a good job making their MT’s look a little more exciting than some competitor’s. I love a Leatherman SuperTool 300 but even I’ll admit it’s a drastically bland looking thing, and the fractal triangle pattern on the handle here is very neat, along with “GERBER- made is USA” etched on both sides of the handles. The 3 outside accessible tools on the Center Drive are what this multi-tool is all about. It’s these 3 tools that Gerber claims is where their innovation in multi-tools is. The main tool of most multi-tools are the pliers and in this case, the pliers are one-hand opening pliers. The pliers have a flat gripping section and a nut and bolt gripping section. The wire cutters are of the replaceable variety and have a notch for wire stripping.

Here we would like to emphasize that in this case we used the basic version of the Center-Drive. There are also other models on the market with an additional bit set, or with other tools. One-handed opening pliersGerber built the Center Drive for construction workers and contractors. It was made to be beefier and more building oriented than most other multi tools on the market. Overall, we think they did a really good job with this one. The big feature, the centerline extended bit driver, works well. It’s a definite improvement on the smaller bit drivers found on most other multi tools. What’s the much-hyped Center Drive bit driver like to use? For a multi-tool bit driver, it’s one of the best I’ve used. There are a few reasons for that. Because the bits themselves are full “3D” hex bits that you would see in a dedicated hex bit driver, I have more faith in being able to put a lot of torque into them. Also, the length of the driver’s arm and it’s center alignment does make it comfortable and natural in the hand. Finally, the bit holder is magnetized so the bits won’t drop out if you are up some scaffolding and you point the driver towards the ground. It’s a nice touch.