Since Teak wood has large pores, you must apply a sanding sealer to prevent over-absorption of the stain. The sanding sealer will limit/regulate the absorption of the stain and help the wood to absorb it evenly. In the opinion of many professionals, Tung oil produces a much more attractive finish than linseed oil. Apply Teak oil on sanded cedar wood surface along the direction of the wood grain using lint free rag or bristle brush. Fixing up my mom’s special teak wood cabinet was the first time I worked with teak. That’s when I began learning about how to stain teak wood properly.

Avoid leaving the teak sealer for too long. All you need to do is condition the surface to absorb the stain better. Apply the Wood Stain After this, use the 220-grit sandpaper over the teak furniture again. You need to prepare the surface so that it can absorb the stains.Teak oil is only able to repel water. Under extremely high moisture conditions, water molecules will easily penetrate through Teak oil layers and get into the wood surface. For this, the surface should be completely dried and dust-free. Using a foam brush, apply a sanding sealer layer. A highly concentrated wood stain that stains wood in one simple application. The formulation is water-based and so is safe to use in all environments, has a very low odour and is non-toxic. In all instances, ensure the surface is clean and any saw dust or dirt has been removed before applying the Wood Stain. Applying Wood Stain Plus, wax doesn’t hold well on Teak oil and you’ll have to wait for so long until the Teak oil surface is completely dry to apply wax. Dining table finished with teak oil

If there are things that you don’t want to stain on the surface such as glass or hardware use masking tape to mask off those areas. A. We recommend leaving the stain to soak into the wood for one or two minutes before wiping the excess off. This will prevent the stain from staining the wood too dark; you can then apply a second application of Wood Stain if you want to darken the wood further. Otherwise, you’ll be buying Tung oil that contains varnish and/or mineral spirits (paint thinner). Which is basically your average “teak oil.” After wiping off the excess Wood Stain, you’ll need to wait for about 10 minutes for the stain to thoroughly dry. Once it’s dry, a second coat can be applied if desired; applied in the same way as the first.

Our Products available in this colour

A honey or golden teak stain: This can enhance the natural warm tones of teak wood, giving it a richer and more vibrant appearance. But if you need to sand deeper, to get beneath tough stains and other discolorations, use 60 or 100 grit sandpaper. Natural Finish: To keep the original appearance of the teak wood, choose a clear or natural teak finish. This will both protect the wood and allow its warm, golden-brown color to shine through.

Patience is the key when it comes to working with Teak oil. When applying Teak oil in a humid environment it can take more than 2 -3 days to dry and you’ll probably have to wait for over a week before applying another coat of Teak oil. Our Wood Stain can be used to restore or change the colour of all types of interior and exterior wood. It can be used to stain old wood, as well as brand new wood and is easy and simple to use. Sand the entire surface with 220 grit sandpaper with even pressure along the direction of the wood grain until you get a nice and smooth surface. By following the above maintenance and care tips, you can ensure that your stained teakwood furniture stays in good condition and looks beautiful for many years. Tip for staining Teak woods How Frequent Should You Stain Teak Wood Furniture And Fences?Instead, it contains either tung oil or linseed oil, or both. Plus, other ingredients, like varnish, mineral oils, and thinners or solvents.