Utilise the same method when working with porcelain paving tiles as with working with stone or concrete. The base on which the porcelain is laid must be able to drain. If the base is non-permeable then EASYJoint Pro or EASYGrout should be used. The wide widths are not a problem and can be 5″ or more; however, when you have really wide joints you also need to have a little more depth, so it doesn’t break up when it is stepped on.

Suitable for Light Vehicular Use On Dense Grade Projects. (For permeable driveway installs Refer to EASYJoint Pro) EASYJoint brush-in patio grout , is a really simple, fast and DIY friendly way to fill the joints in paving slabs and flagstones. Market-leading EASYJoint is ideal for all types of paving such as natural stone, limestone, porcelain, sandstone, Yorkstone, Indian Stone, granite setts and concrete flags. Less water is needed when applying EASYJoint to porcelain paving, as there is little risk of residue staining. You will find that a small amount of water, added to form it into a slurry, will make it easier to fill the joints properly. When applying to porcelain, to ensure an effective joint, the operator MUST strike the joint off, to compact the grout fully. Compaction forces out air and water which helps the joint harden faster.

Step 2. Mix

Years of research and continuous development of our jointing compound makes this a market leader. We sell tens of thousands of EASYJoint tubs every month throughout the United States, UK, and in Europe. Maintain the Width of Joint Throughout. Maintain at least a 3mm gap width throughout the depth of the paving material. Never have this type of paving butted together. See photograph. The same rules apply when working with porcelain paving tiles as with working with stone or concrete. The base on which the porcelain is laid MUST BE PERMEABLE. Freezing weather will increase the set time and will cause the process to virtually stop, it can take many days for the joints to set fully hard. However EASYJoint will eventually set and the weather conditions will not have impaired its integrity in any way.

In dry conditions and warm temperatures and humidity, EASYJoint should be firm enough to walk on within 24 hours and will cure hard within a few days. Yes, theoretically EASYJoint can be used below 3 degrees down to freezing conditions, however in these conditions, the use of lots of water becomes more difficult with a greater risk of staining. Where possible avoid using below 3 degrees, use with caution. Does EASYJoint stain paving slabs? EASYJoint is the original sweep-in jointing Compound and still the best truly "All Weather Paving Joint Compound" available and made in the UK. Do not be fooled by others making similar claims. This #1 product is sold across the world and is favoured by professional and DIY installers.

Deliveries are made between 8.00am – 5.00pm Monday – Friday although we will give you as much notice as possible for early/late deliveries. For a project to be free draining, both the bedding and sub-base must be permeable. To achieve this, assuming a permeable sub-base, where a mortar bedding is used it should be no stronger than 6 parts sand to 1 part cement (6:1). This will ensure good drainage and is perfectly adequate for pedestrian areas. If water is retained in the joint for long periods, rather than passing through, the joint may fail. Weather Conditions Additionally, ensure the project has a suitable “fall” to allow surface water to drain away. Base Mix