Over time the belt can wear down and eventually snap. If you find your motor is running but the drum isn’t rotating, it’s likely that the belt has broken. This is very common and is simply caused by lots of use. Whether your mixer is electric powered, or petrol powered, you can remove the side cover on the machine and replace the belt with ease. Broken Fan If the switch on your Belle cement mixer is faulty or has worn out over time, you can replace it with a new one. Here's a basic guide on how to do it: Bell cement mixer-wiring instructions? Does anyone have a working electric Bell cement mixer (MiniMix).

If your Belle mixer starts and then stops unexpectedly during operation, consider these potential causes: Many, many thanks SG. I have printed this off for him and he is away to the garage with it........... If your machine is particularly old, or it hasn’t been serviced for a while, you may hear a grinding from the gearbox. This is caused by the gears wearing down over time.e. Mix: Let the mixer run until your materials are thoroughly mixed, then turn off the power switch. If your Belle cement mixer switch won't stay on, it could indicate a problem with the switch itself, loose wiring, or a fault in the motor. Consider the following steps: If your Belle Minimix 150 runs when it is first switched on, it suggests that the switch and the capacitor are working. A common cause for the machines to stop running at this point could be that the motor fan is broken or missing blades. This fan is designed to take the warm air away from the motor, so with this element damaged after a few minutes of running the motor can overheat and shut down. These fans are available separately. Blown Capacitor Here are some common issues you may face with the Belle Minimix 150 (and how to troubleshoot and fix them!) Snapped Belt

a new switch eh, i think it will be the wiring. there could be a break within the coloured sleeving of the cable?c. Install the New Switch: Connect the wires to the terminals on the new switch following the manufacturer's wiring diagram or markings. Secure the new switch in place. b. Remove the Old Switch: Typically, the switch is located on the control panel. Unscrew or unclip the old switch and carefully disconnect the wires. Here is a troubleshooting guide to help fix a Belle Minimix 150 cement mixer that won't start or runs with low power: they just came out of nowhere and took me up to their craft, where i was experimented on sexually..........." c. Drum Obstructions: Foreign objects or excessive material buildup inside the drum can impede its rotation. Empty the drum, remove any obstructions, and clean it thoroughly.

hexagonal fitting at top. below that to the right is a single termianl - A1. then below that 4 terminals arranged as 2 rows of 2. I think your wiring directions are great, and he has done it, but the thing still has a problem in the motor, and he now thinks it might be the capacitor.

Returns & Refunds

We hope you found our common troubleshooting tips helpful. Please note that although the tips above can be used they will not always fix the problem, as every machine and problem has different factors attached to it. a. Overloading: Mixing too much material at once can overload the mixer, causing it to stop. Ensure that you're not exceeding the mixer's recommended capacity. then do a test on the wires that you can see both ends of, feed in both neutral and live and any wires you can see both ends of inside the machine. LLP, if i read this thread write he went off to the mixer at 18.29pm with the diagram and had not returned at 02.33am? Minimix 150 (04/2002 - 04/2007), Minimix 130, Maxi 140, Minimix 140, BWE40, BWE60, MiniAlpha, Minimix 110, Minimix 80, Minimix 60