A straight cut is easier than a mitre cut using this method, but should still be done with care. For a straight cut, you'll preferably need a square (tool used to draw perfectly square and 90° degree lines), a pencil and a saw. Read our skirting board fitting cost guide for more information on pricing up your project. Tools you’ll need for the job Carefully and precisely. There’s a lot of measuring involved to get the right angle, and even experienced professionals take their time to get it right.

Skirting is too wide for mitre box - Home woodworking - Skirting is too wide for mitre box - Home

Fixing and installing your skirting board can be as easy as the steps above. Give your interior that finishing touch and look with the installation of a beautiful Orac skirting board . Rinse and repeat– With your first piece of wood cut at 45°, repeat the steps above for the remaining 45° angle that can be used to form your mitre joint. Final Thoughts For a mitre cut, you'll also need a protractor to measure and draw your angle onto the skirting board (this is used as the guide for the saw).This is simple enough, however walls aren’t always square, which complicates the process, and may mean you need to find the angle before mitring. If this is the case for you read our article on how to find your mitre angle after reading this article. Most of our skirting boards come in 2m lengths. Therefore you’ll need to measure your walls to calculate the skirting lengths required and cut the skirting boards to the required lengths for shorter sections. You’ll also need to calculate the angle of any corners and cut the ends of your skirting boards to create the required internal and external corner joints. Internal corners face inwards, and external corners outwards, as shown in the images below. Internal corner example Cut the skirting board angles using the mitre box. With the board positioned correctly, place the saw in the correct gap using the left or right arrow you previously marked as a guide (right for right and left for left). Use your chosen saw to make your cuts and use long, even strokes and pressure. Once the saw goes through, remove the board from the mitre box. To make it a little easier, make sure you cut the wood at an angle and in a continuous motion. This helps to keep the cutting line clear of dust and reduces the heat on the blade to prolong its lifespan.

to Cut Skirting Boards with a Mitre Saw How to Cut Skirting Boards with a Mitre Saw

Mitre boxes contain slots that act as guides for the saw blade, normally at 90° and 45° degree angles. Position the wood – Place your piece of wood on the flat table of the mitre saw and push it up to the fence. Move the wood until your cutting point is directly over the centre of the blade recess on the table. Once this is done, you can prise the unwanted piece off and clean up the edges to make it more aesthetically pleasing. If your new skirting boards are MDF (as most are in this day and age), certain saws will do a much better job. This is because of how MDF is manufactured.Skirting boards are used to provide a neat finish to your walls and protect floor-level plaster. Our range of white Orac skirting boards is easy to install and finished with a white primer ready for a final coat of paint. The majority of homes have rooms with 90 degree corners (or almost!) and most of them will be an internal corner. Make sure there is no debris in the area you will be installing the boards. should there be debris under a board while measuring or marking it can give you an inaccurate measurement when marking. This may then impact on how neat your join ends up. Congratulations. if you have completed these steps you should have a smartly mitred skirting board joint on your external corner.

Mitre Box UK 2023 - Skirting, Coving and Metal Best Mitre Box UK 2023 - Skirting, Coving and Metal

You'll likely need to make various cuts in the skirting board when installing them including straight cuts,internal mitres andexternal mitres. Tools Needed To Cut SkirtingTrade Secret: To ensure your measurements are correct, use a protractor, ruler, and pencil to mark your angles and a mitre box to cut.