A stereo (for Volca FM or Volca Sample) and two mono (Volca Bass, Volca Beats, Volca Keys, or Volca audio channels are available with their own volume faders, mutes, 'Send' knobs for external singanl processing, and low-cut / hi-cut filter knobs in lieu of a parametric EQ. Again, the necessary cables are included. Contents of owner’s manuals and content as found on korg.com may differ. Information on korg.com may be updated as necessary based on changes to the product specification, operating system, included contents, and so on. Additionally, owner’s manuals may be updated to reflect these and other changes with updated production of the product. For customers in outlying areas of the country, the price of the Extended Warranty may be marginally higher, due to the potential for higher collection and redelivery transport costs. NOTE: Korg consistently states that sync cables must be 3.5 mm mono (TS) even though they shipped early Volcas and the Mix with TRS (stereo) sync cables. Some users report sync problems when using mono sync cables, especially when using mono audio cables (mono audio cables are NOT recommended). But this type of problem is not widespread. If you experience timing issues or glitches, make sure that your audio cables are stereo and then carefully go through the global parameters on all your Volcas to ensure that sync polarity is set up properly across all devices. If sync problems persist, remove all audio output cables and continue troubleshooting. Personally, we’d have loved the inclusion of a MIDI thru hub, allowing several Volcas to be chained from a single MIDI or USB input. This would have driven the price up, but many would be happy to pay more for a slightly more pro-spec’d version which does more to integrate the Volcas into a wider setup.

A Volca power adapter should be 9 volts DC, center positive, with a 4.75 mm x 1.7 mm barrel plug per the EIAJ-03 standard. The KVgear PA-2pro and Korg KA-350 and 9V600MACPP are among the few power adapters that meet all of these requirements. If your Volca appears to be malfunctioning or acting strangely, you can reflash the panel processor, which is done by holding REC and MEM while starting the Volca. (Thanks to Pajen for the tip!)You should get an instant answer on whether your application has been successful, though in some rare cases Klarna or V12 may need to look at the application in more detail.

However, the Gear4music extended warranty scheme provides an enhanced service, and is designed to offer a higher level of protection than many 'free' warranties offered by some retailers and manufacturers. The Mixer of the Volca Mixer is straightforward. Connect your external Volca’s audio output to the Volca Mix using the included 1/8-inch TRS cable. Please note that input 3/4 is stereo. In this guide, we will show you how to get up and running with the Korg Volca Mix. With instructions covering everything from syncing to mixing, you’ll learn how to use it to its full potential in no time! Follow the sections below to get started.Pros: 8 channels (2 of them stereo), mutes, panning, 2 aux sends, separate phones and main outs, power for 4 Volcas, same size as Volca. One great feature of the Korg Volca Mix is its ability to power all your Volcas. This means you no longer need to rely on batteries, which gives you peace of mind, as you don’t need to worry about them dying in the middle of a set!