Heating elements for tumble dryers are usually fairly economical to replace and it’s definitely worth fixing your dryer if the heater is at fault. Just to summarize everything that you should do when your Candy tumble dryer has an E21 error code: Heat Pump Tumble Dryers work in a similar way to condenser tumble dryers. They use a heat pump to reuse the hot air that is normally lost and recycle this air through the drum. This reuse of energy makes heat pump tumble dryers the most efficient type of tumble dryer. However, these coils can become ineffective by breaking or misshaping, pulling them too close to or far away from the drum. The condenser unit is located at the bottom of the tumble dryer and can be removed by pushing the latches up or down depending on the model.

You must understand certain things before you begin or attempt any repairs on your own and we want to make these points very, very clear to anyone that decides to investigate one of these or any other tumble dryers: It’s a bit loud: The claimed 65db noise level isn’t far off the money, but this isn’t a whisper quiet option by any stretch. If you need a near-silent machine then we’d look elsewhere. The RAM error is rarer than a thermostat problem but does occasionally occur. If this is the case, then the control board will need to be replaced with a new one.

It’s a standard condenser design, so it uses more electricity than pricier heat pump models – it has a B Energy Rating

But no appliance is infallible, and smart devices can feel doubly frustrating to fix if you’re dealing with digital technology on top of mechanical components. In the washer-dryer model, you may actually find two reset buttons. They’ll be located on the two side-by-side thermostats on top of the heating assembly box. Press both buttons to reset the appliance’s heating settings. The cover will usually be held into place by screws and will need to be levered off so you can break the seal.The answer to that question is the heating element. The heating element uses metal coils that touch the dryer drum just enough to heat it up but not to overheat it. But every appliance encounters problems from time to time. One common complaint for any dryer—including the Candy brand—is that of over- and underheating, for which a reset might do some good. But where exactly is the reset button? This is where the moisture is removed from the air and turned into water that then gets pumped into the water tank. Four Drying Levels - Choose the level of dryness you require - Ready to Iron, Dry Hanger, Dry Wardrobe and Extra Dry

Sensor Dry - The machine will automatically stop the cycle when it detects that the load is dry. This avoids the cycle continuing until the timer ends, saving time, energy and money If you’ve tried resetting the dryer and running a regular cycle but it hasn’t worked, take a look at those vents and ducts. You may just need to pull out some clumps of lint!

GVSC10DCGB-80

The Fault codes above may apply to some or all of the following tumble dryer models from Candy and could apply to other models that use the same electronics and/or software. Remove the condenser unit and clean out any lint that’s trapped inside – You can use a high pressure washer for the best results