When you first set up your Freesat box, you’ll need to programme it to sync up with your TV – don't worry, it’ll just take a minute! Find out how to programme your Freesat remote with just 5 easy steps. When RF Loop Through in Standby was enabled in the System section of Settings, disturbances in the output could be observed for a few minutes after entering standby. When the SX is connected to a Switch that supports both SCR and Legacy modes, disabling SCR on the SX did not activate Legacy mode automatically. Add Reminder” could be shown for a programme on now instead of “Watch” and pressing OK would display error “Unable to set wakeup timer for current event”. The SX did not automatically detect the maximum resolution of a TV connected by HDMI and instead would set it to 1080i.

This Manhattan SX FREESAT HD replacement remote control is manufactured by Classic. Classic have been the leading manufacturer in quality replacement remote controls for TV, Hi-Fi and other electronic devices for over 20 years. During initial setup the Confirm Your PIN step has been updated to make it clearer you need to re-enter your PIN. (1.09) When there are regional variants of channels stored, e.g. BBC ONE NE at channel 1 and BBC ONE WALES at channel 800, the system will always prioritise the primary channel for recordings. Your Freesat remote can even be used to control most televisions! You’ll be able to adjust the volume, switch it on and off and change the source. Fixed an issue whereby seemingly randomly, channels would be removed during the Automatic Service Update in standby. This could happen in locations receiving signals from multiple transmitters with signal variations. The issue could cause favourites and scheduled recordings to disappear.

Our Newsletter

The Automatic Service Update (ASU) previously took place every time the T2-R entered standby. It now takes place only once overnight.

When making a regional selection during Installation, the wrong regional services could be selected.The following changes are from v1.04. Please note that v1.05 and v1.06 were not released publicly as updates. Fixed an issue whereby the volume could not be adjusted on non-HD channels when the ‘Audio Output’ in Picture & Sound Settings was set to ‘Surround’. Ensure your aerial is connected to your SX and an HDMI or AV cable is connected from your SX to your TV. Press the GUIDE button on your remote control. This displays the TV Guide, making it easy to tell when you find the right input.

The T2•R can also be manually set to a resolution in the Picture & Sound section of the Settings menu. This could cause an issue if you set a resolution (e.g. 1080p), then move the T2•R to another TV that doesn't support that resolution. Fixed an issue when using the T2-R with a Pioneer VSX-920-K AV receiver that caused the audio to be lost. If you have any other questions or are facing any issues with your Freesat remote, you’ll find plenty of useful how-to guide and FAQs in our Help section. Pssst, you can even remote record shows wherever you are via the Freesat app 3, and all your recordings will be waiting for you when you get home...) As this is a quality replacement part, it may differ in appearance from the original. About the Manhattan SX FREESAT HD Replacement Remote Control

It’s sleek, minimalist design is ergonomic and intuitive (if we do say so ourselves), making it easy for anyone to use.