HiKOKI (Hitachi) Gas Nail Gun NR90GC2 First Fix 90mm Framing Nailer Including 2x 1.5Ah Li-Ion Batteries & Charger in Carry Case Sometimes you may observe that your nailer is not working sharply and taking too much time to operate. Most of the solutions for Hitachi roofing nailers are almost identical to that of Hitachi framing nailers. So, I will skip the common ones and apprise you about the other troubleshooting ideas for the Hitachi framing nailer. Hitachi Framing Nailer Skips Nails If you do not adjust the nail depth accordingly, it can cause the nails to get driven either too deeply or too mildly. So, pay attention to the depth of drive adjustment. aawp box=”B000H399PC” template=”vertical”] Frequently Asked Question How do you maintain a nail gun?

HIKOKI Powertools UK

Excessive air pressure might be pushing the nails too deep. Reduce the air pressure from your compressor to drive nails more accurately.

This battery is for use only with this version of the NR90. Use with other tools may cause the tool not to operate correctly. Dust, debris, and other materials may damage or clog the nail gun. To prevent damaging or lodging the nail gun, clean every part regularly. After every use, wipe down the tool with a clean rag. Furthermore, if you use this tool daily, remove the air filter and clean it properly once a week. I will discuss the Hitachi roofing nailer first, as it is probably their most beloved listing to date. Nailer won’t Drive Any Nail In the event of Auto Power OFF, to make the tool usable again, detach and reattach the battery. If the tool still doesn't operate, the battery is likely empty and will need re-charging.

HiKOKI Nailers | Powertool World

If your Hitachi roofing nailer thrusts the nails too profoundly onto the surface, you may follow the instruction below. If the battery is attached to the nailer for 12 hours or more, the battery's output will be automatically shut off due to the built in Auto Power OFF feature for the purpose of reducing battery consumption. In this event, the tool will not operate when the trigger is pulled, but this is not a malfunction. There is a rubber-shaped ring around the cylinder known as an exhaust valve. If it is somehow worn, damaged, or missing, remove and replace it as soon as possible. If you face any problem while using the nt65gs finish nailer, follow the following instructions. Push lever not operating smoothlyThis is the latest version (J8) of the popular NR90GC2 gun - now with Lithium-Ion batteries instead of NiCd. If you use your tool daily, lubricate it before every use. Oil will coat and protect every component. While using it irregularly, the oil will pop out through the exhaust, which causes the O-ring to become dry. On the other hand, if the operator lubes the tool only at the time of use, it enhances friction and lessens working capacity. Conclusion