Don't apply in temperatures below 5°C, in damp conditions or if rain is likely before the product has dried. Low air temperature and or high humidity may prolong the overall drying time of the product. CLEAN: Reseal can after use. Clean up spills while still wet. After use, remove as much product as possible from brushes before cleaning with water. Do not store or use in extremes of temperature and protect from frost. COLOUR: The final colour will vary depending on the surface and number of coats. If adhesion is inadequate on previous coatings, lightly sand before application. Make sure wood has been pre treated with appropriate wood preserver to prevent wood and decay. USAGE GUIDE: A minimum of two coats is required, subsequent coats must be applied on the same day no longer than 8 hours apart. If that'snot possible then lightly sand down the surface before overcoating to ensure adhesion. APPLICATION: Apply in dry conditions, above 5 degrees Celsius and when bad weather is not forecast, minimum of 2 coats required.

Q. I want to use a wood preserver on my garden fencing before painting with Cuprinol Garden Shades. Which one should I use? Q. Is Cuprinol Garden Shades suitable for a large log cabin / summerhouse at the end of the garden? A. It depends on how long ago your shed and fence panels where oiled. Cuprinol Garden Shades paint is a water based product so any remaining oil or wax from previous treatments will likely repel the paint. If the timber hasn't been treated for a couple of years it may be OK. In situations like this we always recommend a test area before starting the main project to test adhesion. Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent A. It's important that you use a wood preservative that doesn't contain wax, oil or silicone as these will prevent the paint from penetrating and adhering to the wood. Wood preservers that are advertised as being waterproof and resistant to weathering often contain wax, oil, silicone or a combination of these.Q. Is Cuprinol Garden Shades suitable for garden fences and is it solvent-based? Does it contain any wax? Apply second coat as above. The second coat must be applied the same day as the first. If the first coat is left to dry overnight then the second coat will not adhere to the surface correctly Shake contents of the tin thoroughly before decanting into Cuprinol Spray and Brush sprayer (not suitable for use with the Cuprinol Power Sprayer) A. Absolutely! Cuprinol Garden Shades is suitable for any garden structure including summerhouses and log cabins. If it's a bare wood structure, new or old, its probably worth treating it with a wax free wood preservative first to protect the wood from mould, algae and fungi. Allow this to fully dry before painting. Its important than any preservative used is wax free otherwise the paint may not adhere to the structure.