Unless you plan to turn the router off and let it spin down 2 every single time you want to inspect you'll be lifting off or pulling back the board while the router is running. With the 25mm flute bit I wasn't really restricted for depth of cut- it'd quite happily remove 15mm high spots.

And then you have to put the workpiece back down carefully and push it back into position (still working blind remember) until the bit unexpectedly re-engages with the work. You would also need to make sure that the work piece and its "rails" are fully supported by the router table for the entire size of the piece. I use a 25mm CMT bit, and for the first 2 or 3 runs I cut heavy, maybe around an 1/8th, then as I get closer to final level, I make much shallower passes, like a 1/16th or less. Used with a router and router sled, they also work well for flattening end-grain cutting boards or wood with difficult grain patterns such as crotch wood. And it could project the workpiece towards the operator, not away, leading to a kickback-like injury to your torso.The content contained on this site is provided for informational purposes only and does not constitute professional advice.

You can of course chuck this style of bit into a router mounted in a table and I can envisage some potential uses for it 1, but to then use it for the intended purpose — flattening an end-grain cutting board — would be a bad idea for multiple reasons. We don’t share your credit card details with third-party sellers, and we don’t sell your information to others. VERSATILE WOODWORKING TOOlS: This professional bottom cleaning router bit is not only perfect for wood slab flattening, resurface or plane the top surface of the spoilboard, but also for trimming and slotting/grooving. Where are your hands intended to go and is one potentially in the path the router is trying to take it if this happens?

When doing slots I go 1/8" at a pass and I have a 3 HP motor digitally controlled speed on my table. Yours is one of those tasks where a good-quality router in good nick will make shedloads of difference, as will the quality of the trammel arrangement you contrive -- straightness, parallelism and sag of the crosspiece(s). Though the shank size is similar to the previous W05002 router bit, its cutting diameter is larger than that.