The plasterboards, should be staggered and the joists ideally be perpendicular to long side of the board. https://www.zurich.com/NR/rdonlyres...F-4E5D5F270C8D/0/500045004BG900204WebOpt.pdf. That said, square edge plasterboard is a better choice for ceilings because the panels are easier to seam together when working overhead. Typically, you should board new ceilings with 12.5mm sheets and use 9.5mm panels for design features or suspended ceilings. Why Choose Straight Edge?

Plasterboard Edger GypsumBoard Hand Plane Drywall Edge Plasterboard Edger GypsumBoard Hand Plane Drywall Edge

Content is subject to errors. Please report any problems or comments to our webmaster at [email protected]. Rose™, Sands level & Tool Co®., Superior Tile Cutter®, Inc., Gator Tools®, Hi-Craft®, and Sunset Line & Twine® are Proud Brands of Kraft Tool Co.® While you can use straight edge for walls, too, remember that this choice is only suitable if you are planning on skimming the boards with plaster. For all dry lining installations (no skimming), only the tapered joint will allow you to fill it for a perfect finish. To End Aluminium profiles, also commonly known as aluminium edge trim, are products which are used to protect vulnerable edges on plasterboard walls. Often, an internal partition wall may have exposed tile edges on, or around, the corners of a plasterboard sheet. Additionally, plasterboard edge trim might also be applied to the spaces between walls, joints and floors, to conceal any exposed areas. Hi Prenticeboy , thanks for the answer , one slight problem cannot fit any noggins as have insulated and vapoured? the ceiling now. Do you think if i increase the number of screws on the joists that will suffice ?

Plasterboard and Aluminium Edge Trim | Building Materials

Most houses are under 2.4 metres from floor the ceiling, so a single board can be stood upright giving just the tapered joints running vertically down the walls. lastly my garage is 2.36m wide by 7 m but the ceiling joists run perpendicular to the garage so would i be better fitting the boards(2400x1200) in staggered joints length-ways or parallel to the joists making sure that the joints are on joist centres (the latter way would be easier but one wall is irregular and I would have to scribe each board to fit) is there an easy way to achieve this by leaving a gap at the bad wall side as I'm going to build a stud wall up to that height which will hide the gap . If you want to plaster your ceilings, you can use either a tapered or a square edge, but tapered edges will make no difference if you want to tape and joint your ceilings. For this reason, skimming is always necessary when using square edge plasterboard (unless there are no joints, in which case you can skip this step). Because the tapered edge design requires a specialised manufacturing process, this plasterboard type is slightly more expensive than the square edge variety. However, the price difference is negligible.is this correct I thought the boards were supposed to go together like a french cleat to give them support and a smaller join ?

Tapered Edge for ceiling plasterboard? Square Edge or Tapered Edge for ceiling plasterboard?

As mentioned above, you should use square edge plasterboard for ceilings and tapered edge plasterboard for the walls.Another advantage of the “valley” is that you can use fiberglass mesh or other types of stronger joint tape when sealing the seam. This is a huge advantage in applications that require more strength, such as installing plasterboard in the kitchen or bathroom. also do i fill the V joint (if thats correct then put the adhesive jointing tape on or put the tape on first then fill the joint gap .