Position the bases on the ground, carefully remove the fabric strap that holds the lid down during transit. There will be two screws for each strut, please ensure the legs are attach so that screw fixing are at the bottom of the headboard (see image).

Do not bend, fold or roll your mattress - this will cause serious damage to the fillings, internal spring unit and wire frame. A “Non Turn” mattress should be rotated 180⁰ head to foot once every week in the first 3 months and monthly thereafter.Our Universal Linking Plates should work on most divans, upholstered bed frames and wooden bed frames and are hidden between both beds. This is a very robust fixing and is also commonly used to attach Sofas and Settees inside them which attaches them to the bed base with staples. This helps to keep the drawers closed during After fitting the feet, turn both parts of the divan on their side and bring them together so that the two flat ends meet. To understand how a mattress stays in place on a divan bed, you might find this link helpful: How Does a Mattress Stay on a Divan Bed?. Alternative Methods: Linking Bars and Center Clips Do not use chemical or detergent cleaners as these may adversely affect the fabric and fillings. In the event of soiling, lightly sponge the affected area with a weak solution of soap and water. Avoid over wetting

To join two single divan beds, use a linking bar or strap at the head and foot to connect them. A mattress topper or bridge can also be used to create a seamless surface between the beds. Ensure the beds are of equal height and width, and that all additional components are compatible with your bed models for a uniform and comfortable setup. Conclusion: Mastering Divan Bed Assembly and Maintenance The divan base is typically made from wood and then covered with textile. Many divan beds also have built-in drawers for storage space underneath the bed. If your bed base is in two parts, connect them together using the appropriate procedure for your base type as detailed below. DIVAN BASE WITH U-CLIPS Assembling and maintaining a divan bed may initially seem like a daunting task, but with the right knowledge and tools, it can be a straightforward and satisfying process. This article has aimed to guide you through each step of assembling a divan bed, from preparing the necessary tools to the actual assembly process, and finally, to the maintenance of your bed. Key points covered include: The platform base of this divan bed is 14-inches highThe platform base of this divan bed is slightly over 35cm high. This bed offers you both comfort and support.The headboard can now be fastened to the divan with the large headed screws supplied with the bed, one on each side (or two on each side for an ottoman bed) Where the ends meet, fit the U-CLIPS so that they clamp around the underside timber edges to hold the two parts firmly together. To install bed clips, align the two parts of the divan bed and bring the flat ends together. For U-clips, fit them at this meeting point so they clamp firmly around the underside timber edges. For link bars, attach them to the side of the bed with screws. Ensure proper alignment before fitting the mattress on the now assembled bed base. How do you reinforce a divan bed?