more_sizes:20934,21616 products_related:19225,18801,20934,13081,13079,13077,13075,20251,19346,13079,20785 sku:17899 Junepromo23 LPG and Oil 65. Thanks to their hydrophobic nature, these oil spill absorbent pads will not soak up water and will float on top even when completely saturated, which makes them suitable for applications where oil and water must be separated.

The GoldenRod 496 Fuel Tank Filter is the water block filter for diesel from the leading filtration brand in the agricultural market. It consists of a transmitter and a digital receiver that displays the tank level without going outside. What if the oil in the tank is full to the very top, will this harm the Apollo transmitter and will I receive a correct reading? The reason for the foregoing is that the Ultrasonics bounces a sound from the surface of the oil/liquid and measures the time it takes to then give a reading but if the oil/liquid is too close then it cannot record a time, it, therefore, needs a distance of 100 – 120 mm to give a correct reading.Unlike alkaline batteries, the lithium battery will last for up to 5-7 years before it needs replacing. The technical storage or access is strictly necessary for the legitimate purpose of enabling the use of a specific service explicitly requested by the subscriber or user, or for the sole purpose of carrying out the transmission of a communication over an electronic communications network. Ideal for monitoring heating oil and diesel but suitable too for a wide range of liquids including admixtures, agricultural fuel oil, anti-freeze, biodiesel, bio heating oil, fuel oil, detergents, lubricants, waste oil and water.

I have lost the instructions how do I rematch the unit and how do I know what Pin settings to set on the rear of the receiver plug. The Apollo Standard Ultrasonic comes with two parts, firstly a tank mounted ultrasonic transmitter compatible with most modern plastic fuel storage tanks that have a 32mm port usually fitted to the tank. It can be installed on plastic and steel tanks, however, if the tank contains any ribs, stays or bars for stability then they could cause interference with the ultrasonic signal.Both oil tank level gauges use the same principle of measuring the tank level by using a transmitter fits on top of the tank and the receiver plugs into a socket inside the property to conveniently display the tank level. This information is relayed wirelessly to the receiver unit, which cleverly and conveniently plugs into a standard domestic socket, where it is displayed via an easy to read LCD display. The transmitter unit is fitted to the oil tank and measures the level of fuel inside using ultrasonic technology.

Consenting to these technologies will allow us to process data such as browsing behavior or unique IDs on this site. It can be used with other liquids such as water and some chemicals but for suitability please check with the company. If the tank is filled to the top as described then the oil/liquid will be too close to the underside of the transmitter and will result in intermittent incorrect readings or flashing triangle until the oil/liquid level drops to 100 – 120 mm from the top of the tank. The receiver is plugged into mains electricity and by way of bars on the screen indicates the level of oil/liquid in the tank. Is there an obstruction restricting the signal in the tank, this could include the location of the transmitter on the tank.uk/apollo-ultrasonic-oil-level-monitoring-unit-17899/ 43543 Apollo Ultrasonic Oil Level Monitoring Unit https://www. Yes, you can use either unit on a bunded tank to measure the oil level however this will not alert you should you have an oil leak to the inner tank. The Tank Dryer, or 'tank sock' as it is often referred to, contains highly absorbent silica gel, which when lowered into the tank absorbs up to 350ml of water. The receiver unit displays the level of fuel inside the tank, via an easy to read LCD display, which usefully includes a low level warning alert.