Removal is made easier with a long-handled blade scraper which helps to lift it from the surface rather than spreading it around the wall, which usually happens when using a standard steel scraper. Once confirmed that the artex® does not contain asbestos fibres and can be removed safely with no risk there are a number of different ways this can be done. Firstly it can be “steamed” off using a wallpaper steamer. This can be a very messy and also very slow process. It cannot be done at speed or with the steam plate left in one area too long…if it is, there is a possibility of damaging the ceiling or wall behind it and also the risk that the artex® will liquefy and run everywhere.

It is cheaper to keep a house and add on land than buy a house with more land. That’s why home improvements are popular.” While it is possible for you to remove an Artex ceiling yourself, you should not underestimate how difficult and arduous this can be. You should always be certain your ceiling does not contain asbestos before you begin. To calculate the total cost of Artex removal for your home, you’ll need to start by working out the size of the area of Artex that will need removing. The age of the Artex can also affect the price. The more effort required and the longer the job takes to remove all the Artex, the higher the cost will be. Artex removal quotes

Along with adding extra space to properties, Britons are now demanding something more niche from their houses – a larder.

Depending on when the Artex was installed, the answer to this question will vary. A survey might not be required if your Artex was applied prior to 1985 because it almost probably contains asbestos. It is impossible to know for sure whether your home has asbestos if Artex was put between 1985 and 2000. Asbestos is a huge health risk, and no one should be working with it unless they have the correct personal protective equipment to minimise that risk. The cost of Artex removal Work with textured decorative coatings will not normally be licensable work, as work with this material will usually not meet the conditions in the definition of licensable work in regulation 2(1).” As we’re working on the ceiling, a ladder is needed to access the artex comfortably and safely. It’s up to you where you start to but generally it’s best to start in a corner and work your way across the room. A great solution for covering artex, especially if its got asbestos in it is to plaster over it, covering it away.

What does Artex ceiling removal include?

Boarding over: In this procedure, the original Artex ceiling is covered with plasterboard. The surface is subsequently plastered with a number of layers to make it level. If the area you’re working on is large then you can easily break it up using “stop end beads”. These are galvanised or stainless beads, which can be fixed to the surface and allow you to divide your plastering area into smaller, more manageable sections. It is impossible to get plaster smooth on its first application to the ceiling. Do not attempt to do this. Get an area covered uniformly and wait until it starts to get firm. Then it can be smoothed Before you do however, as plasterboard is as porous as bare plaster, it will need to be sealed. To do this you can use a plasterboard sealer or you can give it 2 coats of watered down PVA or SBR (mixed at 75% PVA/SBR to 25% water).