Ensure that the audio is being transmitted through the earbuds and not through the device’s speakers. To know if this step worked, the LED must turn red. If this doesn’t happen, repeat the above step until the color of the LED changes to red. Follow these steps to reset your Jib Wireless, Jib+ Wireless, or Jib+ Active Wireless earbuds: Jib Wireless

Get the right earbud then press and hold its control button for 3 seconds. This will reset both earbuds. The Jib True have 6mm dynamic drivers in each earbud with a 20-20,000kHz frequency response, 98-103dB SPL, and <3% THD at 1kHz. They support SBC and AAC over Bluetooth 5.0 connection. There's no multi-device pairing support. The earbuds connect in a master-slave configuration, where one (master) connects to the source and the other (slave) to the master. Performance The Jib True have a claimed battery life of six-hours, with the case claiming to provide additional 16 hours. It’s important to note that the specific controls and features available on the Jib True Wireless Earbuds may vary depending on the model. Refer to the user manual or the manufacturer’s instructions for detailed information on how to use the earbuds and access their features.

Step 5: Complete the Pairing Process

With the pairing process complete, you can now enjoy the freedom of wireless audio with your Jib True Wireless Earbuds. Whether you’re listening to music, watching videos, or taking calls, the earbuds offer a hassle-free and immersive audio experience. Touch and hold the same button for both earbuds for 10 seconds to finish resetting. The LEDs should flash blue and then red.

Once both buds have been powered OFF, touch and hold the button on each bud for 10 seconds to completely reset them (this will power cycle them on and off again). For the Push Wireless, this is situated just beside the Skullcandy logo on the earpiece. For the Push Ultra, this is the button where the Skullcandy logo is printed. Meanwhile, the control button is placed on the inner side of each earpiece for the Push Active. Please note – BOTH the LEFT and RIGHT bud for Jib™ True can be used in Mono Mode, this is because the new tech allows Master Role Switching capabilities. How to Reset Skullcandy Spoke Earbuds A closer look at the Skullcandy Spoke Earbuds. (From: London Drugs) The Jib True weigh no more than five grams per side, which is conducive to a comfortable, long-lasting fit that also provides enough stability for a short sprint. However, the design is neither flat nor slim, so the casing of these in-ears means they protrude significantly from the ear, which prevents you from wearing a cap or lying on your side, for example. But an advantage of these robust-looking earpieces is that they are protected from weather-related moisture thanks to their water resistance.

Step 1: Ensure the Earbuds are Charged

Remove both earbuds from the charging case, and wait for a voice prompt stating that the earbuds are on.