Never use unlabelled chemicals and please read the instructions before use. Avoid getting chemicals in eyes, on skin or on clothing. Avoid breathing vapours when opening a container. Avoid creation of dust. Never add water to the product. Always add product to large quantities of water. Use separate clean dry utensils for each chemical and clean after use. Do not add the product to any dispensing device containing residuals of other products. We hope the guide to How Many Chlorine Tablets in A Lazy Spa fully answers your question about lazy spa chemicals. When adding chlorine to your Lazy Spa for the first time, starting with the right dosage is crucial to establish a clean and safe spa environment. Factors Influencing the Initial Chlorine Dosage: Several factors can influence the initial chlorine dosage for your Lazy Spa, including: Safe Handling and Storage: Handle chlorine tablets and chemicals with care, wearing protective gloves and following safety instructions provided by the manufacturer. Ensure proper storage of chlorine tablets in a cool, dry place, away from direct sunlight and moisture. Consider using a storage container like the Strata Small Box.

Considerations for Inflatable Spas: Inflatable spas typically have smaller water capacities than traditional hard-shell hot tubs, meaning the chlorine dosage may vary slightly. Adapting the dosage to your inflatable spa’s specific size and water volume is important to maintain proper water chemistry.The amount of pH increaser or decreaser you need to add to your hot tub depends on the volume of water and how low your readings are. Refer to the dosage information will be printed on the individual chemical bottles.

Initial Dosage: Begin with approximately 2-3 chlorine tablets (20g each) for a medium-sized inflatable spa with a water capacity between 500 and 1000 litres. Adapt the dosage based on water conditions and usage. Drain hot tub to the minimum mark and re-fill with fresh water to the maximum mark, this will help to dilute the excess chlorine. Remove the cover from Lay-Z-Spa to allow evaporation of the chlorine (keep the filter running constantly). This TA Increaser helps raise Total Alkalinity levels, which in turn will help control pH levels and chlorine. Outdoor storage areas for your hot tub chemicals should be situated away from anything flammable. Keep any petrol-powered equipment, like your lawnmower, in a different location. The storage area should also be away from sources of heat, like an outdoor fire pit or BBQ.Determine Dosage: Refer to the manufacturer’s guidelines and recommendations for your specific Lazy Spa model to determine the appropriate chlorine dosage. Factors such as spa size, water volume, and bather load can influence the dosage. For a 1000-litre Lazy Spa: Initial Dosage: Start with approximately 2-3 chlorine tablets (20g each) for a 1000-litre spa. Adjust the dosage as needed based on water conditions and usage. Clearwater pH Plus , also known as ‘pH increaser’ is the best way to increase pH levels that have dropped below the recommended level. To avoid skin discomforts and enable the chlorine in your spa to work effectively, it’s vital that acidity is monitored and controlled. The recommended pH balance of spa water is between 7.2 and 7.6.

Dip a ClearWater® Test Strip in the centre of your Lay‑Z‑Spa, remove and hold it still for 15 seconds.Algae Control: Chlorine tablets help prevent the growth of algae, which can cause water discolouration, unpleasant odours, and an uninviting spa environment. Dissolve the quantity of Chlorine Granules in a jug of warm water and pour into your hot tub. Activate the AirJets for a few minutes to circulate the chemicals evenly throughout the water.

Remove cover from pool to allow evaporation of the chemical (keep the pool filter running constantly). For low pH levels below 7.2 you will need to use pH Plus to help raise the pH levels and balance the water. Never mix different chemicals in concentrated forms. This includes the kit products but also with other products like bleach or weedkillers – a dangerous reaction may occur. Chlorine levels are fluctuating, the pool has been left and gone stagnant or other chemical levels are not correct. Clearwater Foam Remover is designed to control and prevent foaming in your hot tub, which is typically caused by the reaction of water with shampoos, deodorants and natural body oils present on the user.

General Safety Tips

For a 500-litre Lay Z Spa Hot Tub: Initial Dosage: Start with approximately 1-1.5 chlorine tablets (20g each) for a 500-litre pool. Adjust the dosage as needed based on water conditions and usage. When you’re ready to begin mixing your chemicals, you should handle them with chemical resistant gloves. The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. It is also advised to wear tightly sealed goggles and appropriate protective clothing such as long sleeves, trousers, and closed-toed shoes that fully protect your feet from spills. You should also wash your hands after handling chemicals. Drain pool to minimum mark and re-fill with fresh water to maximum mark, this will help to dilute the excess chemical. Clearwater® Multi-Function Chlorine Tablets are an incredibly simple way to maintain clear and hygienic hot tub water. These multi-function chlorine tablets are designed for use with floating dispensers or the Lay-Z-Spa® ChemConnect. They will slowly erode over a period of 3 to 5 days, depending on the amount of water flowing over them.