If you have a reasonably new Dyson cleaner or a new battery, but you still run into this problem, it might be because of a loose battery connection. can anybody help, I have a DC44 which when on high speed cuts out after about 10 seconds, restarts immediately you release and re-pull trigger and continues like this . When your Dyson vacuum is in normal operating mode, and there are no problems, it will show no light. If tying the battery with a tie wire and replacing the battery doesn’t work, it’s time to send your Dyson vacuum for repair.

The outer is neutral, the inner of the cylinder should give a live reading (about 25vDC), and the pin too (about 18vDC). You should stop using the Dyson vacuum cleaner and let it rest until it settles at room temperature before charging or using it again. On some models, like the DC44 Animal, this problem is signaled by a flashing green light when you press the Max mode.On some Dyson vacuum models, flashing blue light means that the batteries are running low and need to be charged. Some models, such as the Dyson V6 Slim, a solid yellow, amber, or orange light on the battery light means that the device is either too hot or too cold or that there is no power coming to the device. For example, on some models, an orange light may indicate that the brush bar is blocked or that there is a problem with the filter. I have tried it with a new battery and its the same, following the answers already suggested on this topic, I tried running it without a filter or bin assembly and it runs for 15 seconds and stops. If You Like Machines, Radios and Cars As Well As Vacuum Cleaners Then Check Out The Official RustySkull Productions YouTube!

When your Dyson vacuum cuts off the power and randomly stops working and flashes a solid green battery light or a blinking max mode light, you should first check if the vacuum is clean and no blockages are causing the shutdowns.

Over a few years, the battery will gradually lose its capacity, and it will more or less discharge itself more often. A solid amber light means a temporary problem with the battery or vacuum cleaner being too hot or too cold. For the most part, all you need is to plug the vacuum in or park it at its dock to recharge the battery. However, if the battery is newly juiced up and fully charged when plugged in, but doesn’t work while unplugged, then it’s time to look for a replacement battery. When you have to flash red lights on the sides of your battery pack, it’s time to change the battery.