However it is possible to prepare these cold beverages with the Hot function. How to use my machine in full safety?

POD COFFEE MACHINES - Nescafé Dolce Gusto

I recently tried out the De’Longhi Nescafe Dolce Gusto Genio S Touch and was impressed with the overall experience. This compact coffee machine is perfect for those with limited counter space, and with just a touch of a button, it lets you create over 50 varieties of coffee and other hot and cold beverages.In addition to this, you can manually reset the machine’s warning signals by pushing the power button for longer than 40 seconds, and this should reset it entirely. If it does not return to green, then there is a serious problem with the machine. When it comes to the Dolce Gusto Coffee Machine, there are typically three colours that may flash or remain steady when the machine is in operation. These are red, orange and green. Depending on whichever colour is flashing or glowing, then you may have a different issue with the machine.

Dolce Gusto Machine: Top Picks for 2023 - House Happy Best Dolce Gusto Machine: Top Picks for 2023 - House Happy

Either press and hold the button again for 5 seconds, or turn the machine off and on again at the wall. If the light on your Dolce Gusto is flashing red, this means that the temperature in the water boiler has dropped below the temperature required. This usually happens in two situations: Case 1: You’ve just brewed a cup of coffee. When you move the brew lever, your Dolce Gusto starts flashing red and does not brew coffee, so there is a sensor inhibiting the machine from brewing coffee. For example, if the capsule holder is not positioned, the power button will flash red and will not allow us to make a coffee until we insert the holder.

🍪 Privacy & Transparency

It is necessary to purge the machine before its first use. To do this, select on the head the maximum amount of water from the machine, drop an empty container under the head of the machine and press the Cold Water position (blue button) and wait for the end of the stream. Repeat the process on the hot water position (red button). Your machine is then ready for use. To test for resistance, a continuity test should be performed. You will need to identify it and then remove its pods. Place the test probes at its ends and if the result is different from 0 or if the device does not beep, it is necessary to replace the resistance. The electronic card no longer supplies the resistance