They are a very cheap but very efficient choice of bio media. They work just as well as all the other expensive bio-media on the market while costing less and being just as effective. By comparison, the noise from the SunSun filter I also tested was 56.4. That might not seem like that much, but the decibel scale is logarithmic, so each decibel point you go up is 10 times louder than the point below it. You get a super nifty maintenance schedule that tells you how often to replace/maintain things like the o-ring seals. Noise As you might’ve guessed, the Fluval FX6 is a bigger and slightly more powerful version of the other. Most of the specs on the Fluval FX4 are just upped with the Fluval FX6. This essentially means that your decision has to be made on what you need rather than who’s the best since it isn’t exactly a fair comparison if one is for more giant tanks and the other for smaller ones.

Fluval FX6 Review: Best Canister Filter of 2023 - Epic Aquarium Fluval FX6 Review: Best Canister Filter of 2023 - Epic Aquarium

I got the FX6 set up, added seasoned filter media from one of my established tanks and added the goldfish. So, great biomedia capacity, plus great mechanical filtration, all with an ultra-quiet but really powerful motor. That’s pretty damn perfect in my boat! If in doubt go to nearest glass merchants and grab some scrap or buy some small pieces to practice on Aquaristikshop.com: The Installation material is included. The filter comes completely and ready to use.

Should you use the media that comes with the Fluval FX6?

Performance– how well does this filter maintain water parameters? Does it do a good job of removing fish poop?

Fluval FX6 External Filter System - Complete Aquatics

Sometimes after setup, you may not be getting the desired flow rate or notice that you’re FX6 has low flow. Now, you will move on to the water exchange valve at the bottom of your canister. You will remove the exchange valve and connect the respective hose with the canister filter. This will be your entry point for eliminating all waste and refiling the canister filter with clean water. The same handles that let you pull out the baskets also serve to hold all the baskets together. Once you’ve got them out, you just pop off the handles so you can separate the baskets.

Pot Scrubbers For Bio Media

Now that you know when to clean your aquarium with an FX6 filter, it is time to learn how to clean FX6. Here are a few steps to get you started with cleaning your FX6. If you do end up needing to get in there and do some cleaning due toclogsor maintenance issues, there’s an easy to usepurge valveon the bottom.Purge valvesare a necessity for canister filters and can makewater changeseasy, but some of them are a pain to use. Fluval designed theirs perfectly and we think a handful of other manufacturers could learn a thing or two from the subtleties of their design. Media baskets

Fluval FX6 Media set up – (Simple) - KaveMan Aquatics Fluval FX6 Media set up – (Simple) - KaveMan Aquatics

I'm sure with that powerhouse of a filter you don't really need to worry about a few mm difference in diameter restricting flow, or damage especially since it has "Smart Pump Technology". And none of the other canisters I looked at had the super cool drain thingy that lets you pump the water out of the body of the canister when you’re doing maintenance. You have to carry the canister full of dirty water to the sink with the rest. As you can see it’s very important to complete any preventative maintenance and on-going care for this expensive filter. To shop this in factories they have a coolant running over the bit, these isn't viable on a tank so the best way I have found is the fill the bit with loose ice (the White crap that builds up in your freezer) it works a treat I've drilled dozens of holes that waySo if you don’t feel like reading a full review and want to skip to the spoilers, here’s the gist of it: Like every other product, this one has its flaws and can most often be solved in a pinch. There’s a pattern of misconceptions and problems that usually happen with this product, and you’ll find them explained below. Startup Issues If you were impressed by the capabilities of the FX6 then you might not care about the design one way or the other, but if you had to choose you might as well go with the pretty option! Setup Noice is one of the most overlooked factors to aquarium products, but we place a premium on the ability for gear to run quietly.