Based on his extensive experience of constructing feather edge fencing, Jon realised that there was a requirement for a tool that could assist with the accurate spacing of the feather edge boards. With regards to screwing I've done it when repairing old fencing that is showing it's age where the vibration of hammering may be an issue and once when someone had asked for it when they didn't want too much noise being made. Each board is meticulously crafted with a feathered edge, providing a sleek, overlapping design that creates a seamless, secure barrier.

This spacer will save you time and assist you with keeping your fence boards evenly spaced during the construction of your feather edge (Close board) fencing.I've just put up a run of featheredge and used two fixings per board (obviously per rail - thus 4 fixings per board! If the item comes direct from a manufacturer, it may be delivered in non-retail packaging, such as a plain or unprinted box or plastic bag.

They’re bright yellow too,” continued Jon “so should you ever have to put it down you will be able to find it again, no matter how good your tools are at hiding from you! If you have a sloping garden, Feather edge fencing is an ideal solution for this due to the very nature of its construction which lends itself to custom designs. I'm in the process of erecting about 40m of 6' fence, and would like to know the potential pitfalls. When installing a feather edge fence, it is crucial to overlap the boards at the correct distance apart. Bright Green in colour so helps you find it easy and with a keychain attached to avoid losing it in the first place!

After setting your first fence board vertical with a spirit level, you can then use this spacer to evenly space and ensure you have the correct overlap between boards. If you’ve already done that, your item hasn’t arrived, or it’s not as described, you can report that to Etsy by opening a case. Therefore, it is important to maintain a balance between adequate overlap and the fence's appearance and strength. A decking area is a great way to make the most of space that can otherwise go unused such as sloping and uneven areas, creating a level space for entertaining, eating outside, or just sitting out and enjoying the sunshine.

We suggest that you discuss this with them and this is the side that you will be doing much of the work (fitting the feather boards) so you may trample plants etc.As a rule of thumb, the recommended overlap distance when installing feather edge boards is approximately 25mm (1 inch). Our eco-friendly, water-soluble wood paints are brought to you in partnership with Thorndown Paints. The problem with these is that they generally tend to end up between your teeth when you next reach for a hammer, nail or nail gun, the next board or your spirit level. Measure your fencing run in metres and divide by 3 (or by whatever length rails you are using) you will need this number of posts plus an extra one for the start of the run.