Tile Doctor Remove and Go is very effective at removing impregnating sealers and can be applied undiluted and used in the same way as Pro-Clean. It's worth noting that Pro-Clean is better with the removal of topical sealers however if you are unable to determine which sealer has been used previously then you may need to utilise both products. Clean the floor using Tile Doctor Pro-Clean Heavy Duty Tile and Grout Cleaner which ishighly effective against Wax Sealers, Grease, Grime and general dirt build up. These tiles are generally made in a factory with some artizan involvement however the quality of the kiln is far better than Mexican and so are easier toclean, to seal and to maintain; naturally thisresults ina higher productioncost.

For architecturally specified sealers we recommend Tile Doctor Pro-Seal which is a water based impregnating sealer suitable for all types of honed stone including Travertine. Regular Maintenance of Travertine Once the floor has been cleaned and dried apply Tile Doctor Seal & Go sealer with a paint-pad applicator and tray. Spanish or Mexican terracotta tiles are very porous and may require up to 8 or 9 coats of sealant, always allow to dry before applying the next coat. FRENCH, ITALIANOR SPANISH (semi hand-made) If you require advice on how to clean your old stone floor and tile grout to make it look like new and then how best to reseal it so it keeps looking new you have come to the right place.

Sealing a Marble Tiled Shower Room Floor

The best way to clean and polish Travertine wall tiles is with a hand-held polishing machine using a set of six inch Burnishing pads, we find using chemicals less effective on vertical surfaces and can lead to staining. The process is thus, spray the No.1 Red Burnishing pad with water then apply to the wall tile until the dirt and old sealer had been removed. Then switch to a No.2 Blue Burnishing pad and repeat the process followed by a No. 3 Yellow Burnishing pad straight after. This method is also the best way to treat the build-up of Limescale as the acidic cleaners commonly available for this will actually damage the Travertine.

There was also a damaged tile that needed replacing which I was happy to do. We often get asked to replace tiles but we don’t really take on tiling work unless it’s part of a bigger renovation project.The first step was to use a rotary scrubbing machine together with Tile Doctor Pro-Clean which is a high alkaline cleaner for use with tile and stone. This action breaks down the soil in the tile and releases it along with the remaining old sealer. The floor was then pressure rinsed to ensure all of the dirt was removed from the pores of the tile and grout lines scrubbed by hand with a stiff brush. Once I was happy the floor was clean it was given a thorough rinse to remove any remaining chemical and left it to dry. After an hour, the Colour Grow had dried and I began building up coats of acrylic seal ‘Seal & Go’. Terracotta is quite a porous material and the floor took six coats of Seal & Go before I had achieved the right level of sheen desired by the customer.

This gives the floor a good mechanical scrub and works wonders releasing the ground-in dirt and soil from the tiles. The strong dilution of Pro-Clean will also remove any remaining sealers from the tile, however after sixteen years I doubted there would much trace of sealer left. Once done the floor was rinsed with water and all the soils removed with a wet vacuum. After allowing the floor dry out overnight, I returned to apply two coats of Tile Doctor Colour Grow, which is a solvent-based, impregnating sealer designed to enhance the variety of natural colours and shades in the stone. It also protects the stone against daily exposure to chemical-based shampoo and soaps. Sealers will break down after 2-3 years (depending on usage and cleaning products used) so for regular cleaning use a sealer friendly cleaning product such as Neutral Tile Cleaner which has been especially formulated for the regular cleaning of Sealed Stone and Tile surfaces keeping them fresh with a pleasant lemon scent. Efflorescence After cleaning the pH level of the floor will be alkaline so its best to neutralise this by giving the floor an acid rinse using Grout Cleanup. Using this product has other benefits to, ie.: Following the initial clean the colours were already much stronger. Next step however was to improve on that by giving the floor an acid rinse using Tile Doctor Grout Clean-Up. This removes mineral deposits and generally brightens up the appearance of the tile. After another round of scrubbing the floor was rinsed with our high-pressure washer and then vacuumed, extracting all of the dirty water and dirt away in one go. The floor was looking a lot better and was left to dry overnight.I then worked the floor with 200-grit carbide brush fitted to a rotary machine to remove the dirt ingrained in the clay pores of the tile. Some of the grout was loose and dislodged in the process, however my client was expecting this and had already arranged for his tiler to complete a full re-grout once we had finished cleaning. The soiling released by the cleaning process was rinsed off the floor with water and extracted with a wet vacuum. Sealing a Quarry Tiled Lobby Floor I applied two coats of our solvent-based impregnating sealer known as Tile Doctor Colour Grow. As the name of the product suggests, Colour Grow not only protects the tiles against ingrained soil, it also thoroughly lifts and enhances the natural colours in the stone. Having agreed my quote the only thing that was left was to agree a date to do the work which would take two days. As it turns out they had planned a holiday and so I it was agreed I would do the work whilst they were away to minimise disruption.