This pump is for use with storable pools only. Do not use with permanently-installed pools. A storable pool is constructed so that it is capable of being readily disassembled for storage and reassembled to its original integrity. A permanently-installed pool is constructed in or on the ground or in a building such that it cannot be readily disassembled for storage. YOU MUST ENSURE THE FILTER PUMP IS UNPLUGGED BEFORE ANY MAINTENANCE BEGINS OR SEVERE RISK OF INJURY OR DEATH EXISTS.

Each LED indicator represents 2 hours of working time. You can push the Set Working Hours Button to adjust the desired time. Filter: This function is used to filter pool water and should be positioned here 99% of the time. Water is pumped through the sand filter, where it is cleaned and returned to the pool. The pump is not intended to be bonded to the equipotential bonding grid. DO NOT BURY CORD. Locate cord to minimize abuse from lawn mowers, hedge trimmers, and other equipment.

Check out these fantastic products

The use of adhesives or other attachment methods that prevent access to suction piping or SOFA components requiring periodic servicing is prohibited. Fifth step: open the metal ring in the middle of the tank body and open the upper part of the tank. Sixth step: take out all old sand from the tank and rinse the bottom part with a garden hose to be sure it is clean. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Do not dry run the filter pump. Make sure both the pool's Inlet and Outlet valves are fully covered by water before operating the Filter Pump. POOL SUCTION FITTING INSTRUCTIONS IMPORTANT: when performing this operation, please be sure that the O-ring is in the correct position and completely clean from the sand.

In case of a power outage or the GFCI being unplugged, the running time of the product will be reset to a 10 hour default and the previous set will be deleted. Pushing the test button on the GFCI does not stop the timer. To stop the timer, you have to unplug the GFCI.

Find out General FAQs

Using the pump with an unmatched electrical supply is dangerous and will result in catastrophic failure of pump. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. USE ADAPTOR PLUGS. Consult a qualified electrician for any questions related to the validity of your plugs grounding. Handle the pump with care. Do not pull or carry the pump by the power cord. Never pull a plug from the outlet by yanking the power cord. Keep cord free from abrasions. Sharp objects, oil, moving parts, and heat should never be exposed to the filter pump.

EN60335-2-41 TEST standard requires the filter pump must be vertically fixedon ground or a certain pedestal made of wood or concrete before use. There should be two holes 9mm in diameter on the pedestal, the space between which should be 163mm. Put filter pump on the pedestal and fix them together by fasten the bolts and nuts. All the pedestal parts should weigh over 18kgs at least to prevent the pump from accidental falling.

About Inlet Stopper Plug for HydroJet™ Spas

IMPORTANT: Certain types of hard grass can grow through the liner, as can aggressive bushes/plants by the sides or through the pool. If this happens, it cannot be considered a manufacturer problem. Open/unscrew the Air Purge Valve on the top of the Filter Pump; air is released as water fills the Filter Pump. NOTE: Atmospheric conditions may affect the performance and life span of your filter pump. Unnecessary wear and tear may occur during periods of cold, heat and exposure to sun. Whenever possible shelter the pump from these conditions. No modification shall be made to a SOFA structure or flow path unless the new configuration has been certified as new SOFA. Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.