As well as these rules, Primers and Ammunition are also licensable, meaning that you must hold a Section 1 Firearms Certificate or Section 2 Shotgun Certificate (dependant on the primers or ammunition you purchase). Use a water (whet) stone to do the flats on octagonal barrels, it'll preserve the markings and dovetails sharp-edged and the flats flat.

Gently spread the solution to the part to be blued as evenly as possible, applying a clean applicator. Eighth, One of the simplest of formulas in the book works very well, a 2 percent by weight solution in distilled water of Ammonium Chloride. With 16 years of experience working for Commercial Metals Company, Christopher specializes in designing modern infrastructure, metal recycling, fabrication, performance steel, and construction services. Mark Lee makes the process fairly easy, yet it is still time consuming, requires the right tools, and patience. Ballistol Quick Blueing is designed to be user-friendly, allowing both novices and experienced gun owners to achieve impressive blueing results with ease.

Mr John Gallatly's instruction about soaking the parts in old motor oil and a dewatering oil caught my attention and I need to ask if by "old" motor oil, he means used oil? The completely even finish is more of a satin compared to what you would get from Oxpho Blue using the same prep.

The solution should never be applied heavily enough to run, but rather a thin coating that evaporates within a few seconds each pass. However, among all the techniques, hot-bluing and cold-bluing are the most popular because you can do them at home. You’ll need a sander, alcohol wipes, wax and grease remover, bluing solution, cotton balls, sandpaper, a soft cloth, and gun oil.Ballistol Quick Blueing delivers exceptional blueing results, transforming the metal surfaces of firearms into a rich, deep blue finish.

You can use any of chemical cleaners such as sodium triphosphate, naphtha, denatured alcohol, and acetone. I have since read that some of the old rust bluing formulas contained cyanide which have since been discontinued for obvious safety reasons. Different forms of bluing have been used by gunsmiths and gun enthusiasts for centuries now to protect guns from wear and damage, but you might still be wondering what gun bluing is. dry off metal make sure to have some cotton or vinal gloves even as you clean them, you dont want to touch with bare hands, and use some thin wire for a handle when boiling.After the degreasing, flush or scrub the metal in very hot water to remove any residual chemicals and allow to cool thoroughly before applying the fist coat of solution with a clean swab, do not swamp it, merely moisten. The Hot Water Cleaning Tank Burner is designed for Dicro-Clean 909 cleaning solutions or hot water rinse tanks, with a single row of holes in a ¾" pipe for efficiency.

A: While Ballistol Quick Blueing is generally safe to use, it is recommended to take appropriate safety precautions. The above is hazardous and should generally be performed in a lab environment by an experienced technician. I slowly added the powder and wow I was surprised how much yellow smokey fumes came from the bottle --is this quite normal? I cleaned the piece of barrel with carb cleaner (mostly acetone anymore, the EPA took all the good stuff out) and applied a thin coating of my Tarn-X soup to the workpiece. I also extended my boiling times to between 10 and 15 minutes,I'd boil one piece while carding,heating and coating the other.Sixth, the cleaned surfaces must be completely wettable by distilled water, if the last time you rinse the part it is not covered by an absolutely continuous film of water it is not clean yet. You probably loved the sleek metallic beauty and well-oiled performance of your gun when you first bought it. I just did my third boil and wipe and this thing is looking good, black in the shade and deep dark blue in the sunlight. Bluing only works on ferrous materials such as steel, cast iron, or stainless steel, for protecting against corrosion because it changes iron into Fe 3O 4. FredB wrote:i used this method 30 years ago in a company laboratory with a glass screen between me and the solution.