Again, good chance of 1 or more bolts fouling on the latch so swap out current latch for a 'bolt through tubular latch' With a door handle with a round base, the screws are fairly short and tighten into the wood that's between the handle and the tubular latch

Phillips Snap Off Screw M4 | Toolstation Phillips Snap Off Screw M4 | Toolstation

As for a repair to holes, personally think not needed as you will be drilling through these holes from one side to another Used to fasten door handles, knobs, roses and escutcheons. These screws with sleeves are used to replace existing or damaged screws that attaches two handles together. The handle on the door has come off. It looks like they've used some sort of wood filler. I'm happy to put on a different shape handle and paint the door to cover any damage but what can use to fill those holes that I can drill again and put a new handle on. I have some Toupret but don't know if that would do the job.

The bolts will secure and clamp the handles to the door so that little damage is neither here nor there Could do away with the latch and swap for one of these as its a stairs cupboard; (as an example only) Join board or carcass units together. Male and female parts screw together to give a strong tight fixing. For use with 28-36mm material. You need to drill these holes through accurately so they line up otherwise can be fiddly to get both sections of bolt to engage Depending on the diameter of the handle base, if you used a longer screw, there's a good chance that 1 or more screws would line up with the latch and prevent you from fully winding them in

Door Handle Fixing Screws and Sleeves M3,M4 Nickel 36pcs Door Handle Fixing Screws and Sleeves M3,M4 Nickel

The door bolts simply pass through the door and latch and screw into each other (as I explained above) Obviously you can only pull forward a few mm until bar hits edge of hole but often enough to loosen the latch Best to change the latch as well for a ‘bolt through tubular latch’ then no problem with using 4 handle bolts

Brand

How to use: Drill a hole through the door leaf, place door handle on the door to match up with the hole drilled and push the screw trough the door handle, door leaf the handle on the other side. Attach the sleeve and tighten up. Follow these instructions for all 4 holes in the door handle. The result is a handle securely fixed with screws that cannot be pulled through. M3 no snap off screw – can be cut with electrician pliers Both the sleeve and the screw has a slotted head.