If you're looking for even more variety and an abundance of different flavours and scents for a similar cost, Chemical Guys offer some really good products, but you'll easily become overwhelmed by the options if you're not careful. READ NEXT: Yes, apart from the front windscreen we would recommend Polar Seal can be used on all exterior surfaces. Polar Seal is a durable hydrophobic coating. However, it does not offer the same long-term protection as Ultra High Definition Wax or Extra Gloss Protection.

Spray Polar Wash onto the vehicle, starting at the bottom, ensuring all exterior surfaces are covered, including glass and wheels. We would not recommend agitation as part of a pre-wash process. Allow the product to dwell on the paintwork for up to 10 minutes. This will allow Polar Blast to safely soften and loosen soiling, before rinsing with your pressure washer. The Autoglym Polar Kit contains 3 products used via a pressure washer to maintain & protect your vehicle. No, it is not necessary. The vehicle should be clean before applying Polar Seal, ideally with Polar Blast and Polar Wash. Polar Seal should be sprayed over all exterior surfaces apart from the windscreen and then rinsed off immediately. If your vehicle only has very light soiling and you are using in place of shampoo. Please rinse vehicle first before applying Polar Blast. You can either allow to dwell and rinse without agitation or agitate with a sponge or wash mitt prior to rinsing.

More items to consider

Spray Polar Seal onto the clean, wet vehicle, ensuring all exterior surfaces are covered, although avoid direct application to the windscreen. Keeping your car exterior clean is a great way to take care of the aesthetic of your car as well as its longevity. Follow our step by step guide. We would only recommend its use in place of a shampoo if your paintwork has very light soiling. In these circumstances please ensure you rinse the vehicle first to remove any heavier contamination. We would not recommend it is used with other Autoglym products has these have not been developed to be used through a pressure washer. Dilute the product at the recommended rate, outlined on the sidewall of the Polar reservoir bottle (D).

Only a small amount of Polar Seal is required. Pour no more than 40ml (four capfuls) into your foam bottle and then add at least 200ml of water. This should be all the finished solution required to cover your vehicle. There is no benefit in using any more than 40ml as over application can compromise the finish. Spray Polar Blast onto the vehicle, starting at the bottom, ensuring all exterior surfaces are covered, including glass and wheels. Leave Polar Blast time to dwell and loosen dirt for up to 10 minutes, although do not allow it to dry on. Thoroughly rinse and dry your car to reveal a high-gloss finish that is protected with a hydrophobic coating. The car must be dried with a cloth and not allowed to air dry as water spotting may occur. Polar Seal is wax safe and we would recommend that if there is wax on the paintwork that Polar Seal is used as a top up. There is no need to remove the wax or other protection before applying Polar Seal.Polar Blast is used as a pre wash snow foam and produces a highly dense foam blanket to your vehicle to help maximise cling time and loosen dirt.