These connectors are often also very colorful that helps you locate and indicate them. Depending of the type,RC Battery Connectors can withstand very high currencies and voltages. Resembling very much original XT-60 connector is the Team Corally PRO 3.5mm connector. It is as handy as XT-60 but has longer plastic tabs inside the connector to prevent it being connected in reverse polarity.

Did you know.. Original manufacturer and patent holder of the original designfor XT connectors is Amass Electronics. When soldering Traxxas connectors, first solder the leads totabs and push them in to connector housing afterwards. DHL Express and UPS Express are our fastest delivery options. Both options can reach almost anyplace inEU in 1 day, but some places take 2 days. This connector has two spring-loaded terminals in 90 degree angle to each other. When done right, it is impossible to connect it wrong what makes it very safe for even beginner to use. It is anyhow pretty small and many people find it hard to connect as it can be very tight. Normal sized Tamiya-connector is white and slightly transparent. Mini version has light green color.The above figure is for reference only. Due to different production batches, DJI provides two kinds of gimbal protectors that are slightly different in appearance. The two gimbal protectors have the same function and can be used in the same way.

JST-XH can be most commonly be found fromLiPO-battery balancer cables. They are built in same say than JR-connectors but are bit larger and can withstand higher voltages than servo cables. These connectors may have different amount of pins, especially with LiPO balancer cables. Did you know.. JST-XH connectors were developed by J.S.T. Mfg. Co. (Japan Solderless Terminal). They can be easily confused with Molex connectors. There are many sizes of these available. In RadioControl Cars most commonly used are sizes 4mm and 5mm.

Servo connectorsare standard in world of RadioControl Hobby and have been used since early days of RC. Some manufacturers use slightly different housings. Did you know..In some cases, Mini-Tamiya connectors are wired in reverse polarity. This is often the case with airsoft guns, where the square profile terminal is the negative terminal and the rounded terminal is the positive terminal. These are easy to build. Solder or crimp the cablesto terminals with pliers or crimping tooland push them in to housing.