We can supply this trunking in any width, any depth, any number of compartments (note maximum span for load bearing lid is 110mm). Connect the trunking body to the junctions and floor boxes by inserting through the box connecting sleeve, cutting lengths as required. This trunking is available in any width, any depth, any number of compartments. The minimum screed depth required for use with service boxes is only 55mm, (500 series and 2000 series only, 65mm minimum for 700 series or Minima) Cables are placed into the trunking body. Once wiring is complete place the trunking lids on to the bodies and secure using the supplied joint cover sleeves. Floor service outlet boxes can be fitted at any point along the trunking run, at any time after screeding when using trunking at least 55mm deep.

Position the floor boxes and junction boxes to your lowest anticipated screed height and secure to the floor.The trunking should be laid on a supporting flat ribbon of screed to avoid the distortion of the trunking lid. A range of heavy duty floor trunking for use in screed with the lid flush with the finished floor level, giving the flexibility of re-wiring and moving outlet points without disturbing the screed. The body is made from 1.5mm galvanised steel and the load bearing lids are made from 2.5mm galvanised steel. A range of trunking that is designed to be buried in the floor screed, with services brought out through service outlet boxes and junction boxes. It is designed to be laid and wired prior to screeding. The trunking is made from 1.2mm galvanised steel. The upper surface is a removable cover, either flat or recessed to take floor covering. For recessed lids a stainless steel option is available.